We have collected the most relevant information on 50 Db Audio Pad. Open the URLs, which are collected below, and you will find all the info you are interested in.
Line level signal to microphone input adapter
http://arrakis-systems.com/pdfs/Microphone%20Input%20to%20Line%20Level%20Adapter.pdf
50 db PAD Professional audio Line level output from your microphone processor is typically +4db. The audio consoles Microphone input is at –50db. To match the audio level use the resistor attenuator shown below. 47K Ω Resistor (+) Hot Output (+) Hot Pin 2
Line signal to microphone input - Audio | Video | Circuits
https://www.epanorama.net/circuits/line_to_mic.html
Attenuation: 50 dB Input impedance: 33 kohm Output impedance: 100 ohm Input signal: Unbalanced line level input Output: Unbalanced microphone output 20 dB PAD for line to electret microphone input. This circuit is designed to interface consumer (-10 dBu) signals to microphone input that is designed for two-were electret microphone capsules.
HOW TO BUILD AN AUDIO PAD - FM Systems
https://www.fmsystems-inc.com/build-audio-pad/
HOW TO BUILD AN AUDIO PAD. ... Also you must choose a dB table value half that of the Pad loss you want since the loss will occur on both sides of the balance circuit. So the for 2 dB loss you would choose the values in the 1 dB loss table and divide the R3 value in half.
Parts Express Speaker L-Pad Attenuator 50W Mono 1" Shaft 8 Ohm
https://www.parts-express.com/L-Pad-50W-Mono-1-Shaft-8-Ohm-260-255
The L-pad then sees an 8 ohm load and functions properly. The 4 ohm resistor will drop the tweeter output by 3 db, but tweeters are nearly always considerably more sensitive (db/w/m) than woofers, so the loss of 3 db is of little concern. You may want to use a audio grade resistor such as Mills or Dayton.
Now you know 50 Db Audio Pad
Now that you know 50 Db Audio Pad, we suggest that you familiarize yourself with information on similar questions.
