Antec 900 Front Audio Jack

Antec 900 Front panel headphone jack doesn't work w/ X-FI ...

https://hardforum.com/threads/antec-900-front-panel-headphone-jack-doesnt-work-w-x-fi.1414854/

Dec 29, 2006. Messages. 314. I have X-FI XtremeMusic and Antec 900 case and I need to connect my headphones to the front panel audio jack because the cord won't reach to the back. The card has only 4 pins on one row but the audio connector has 5 pins on two rows, with 1 pin blocked off on the upper row. So far I've tried plugging in the bottom ...

Antec 900 Front Audio jack does not work. Any help ...

https://www.reddit.com/r/techsupport/comments/po9hq/antec_900_front_audio_jack_does_not_work_any_help/

Antec 900 Front Audio Problem, please help!!! | AfterDawn ...

https://forums.afterdawn.com/threads/antec-900-front-audio-problem-please-help.586563/

Hi I have a problem with my Front Green Audio jack, it's like it's not detecting mirophones/headphones at all. I have the Realtek sound driver installed and the rear jack works fine, it's just like this front jack is disconnected. ... Oh and on my 'previous' Antec 900 case, the Turn on/off button didn't quite work .... since it didn't turn on ...

Antec 900 Front Panel Connectors | AnandTech Forums ...

https://forums.anandtech.com/threads/antec-900-front-panel-connectors.22342/

Help with audio on a p8p67 pro mobo and Antec 900 case ...

https://www.reddit.com/r/hardware/comments/hqsux/help_with_audio_on_a_p8p67_pro_mobo_and_antec_900/

The antec 900 has a wire to connect the front panel audio to the motherboard using either "HD audio" or "ac97'". The problem is that with the new wire layout the "HD audio" won't reach that port I pictured above, I can just barely reach the ac97, so I have to figure out a way to make it longer using like an extension wire or something.

Nine Hundred - Front Port Replacement - Antec America support

http://support.antec.com/support/solutions/articles/1000184694-nine-hundred-front-port-replacement-

9. Pull out the front port assembly. Be careful not to get tangled in the LEDs, power and reset wires. 10. Mount the replacement front port assembly and secure it with the four screws from step 8. 11. Flip the top panel back over. 12. Replace the panel on top of the chassis starting with the front clips and working your way back. 13.