We have collected the most relevant information on Ata 186 Audio Parameters. Open the URLs, which are collected below, and you will find all the info you are interested in.
ATA 186 H323 Audio parameters | CCIE Voice notes
https://cciev.wordpress.com/2006/05/26/ata-186-h323-audio-parameters/
ATA 186 H323 Audio parameters Posted: May 26, 2006 by sankar in Analog, ATA186. 0. LBRCodec: If LBRCodec is set to 0, ATA chooses g723.1 as the Low bit rate codec. (You can have up to 2 calls on the ATA at g723.1)
Cisco ATA 186 and Cisco ATA 188 Analog Telephone …
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cata/186_188/3_0/english/administration/guide/sccp/sccp3_0/sccpaape.html
Note The term Cisco ATA is used throughout this manual to refer to both the Cisco ATA 186 and the Cisco ATA 188, unless differences between the Cisco ATA 186 and Cisco ATA 188 are explicitly stated. Note This section contains recommended values for the United States and other countries as configuration examples for certain parameters.
Configuring and Troubleshooting the Cisco ATA 186 …
https://www.cisco.com/c/en/us/support/docs/voice-unified-communications/ata-180-series-analog-telephone-adaptors/19083-ata-fax.pdf
You must configure these parameters in order to configure the Cisco ATA 186. Audio Mode bit 2 (18)=0 Enable detection of FAX CED (answer) tone and switch to FAX mode ... You must configure these parameters in order to configure Cisco ATA 186. Audio Mode bit 0 (16)=0 Disable VAD bit 1 (17)=1 Use G711 Codec Only • • Rx/Tx Codec 1/2 for a/u ...
Cisco ATA-186(sip) - support.catnextgen.com
http://support.catnextgen.com/assets/img/voice_gateway/file_config/cisco-ata-186.pdf
Audio Parameters Cisco ATA 186 (SIP) RxCodec TxCodec LBRCodec AudioMode NumTxFrames FXSInputLevel Audio fax mod ox00120012 2 F)(SOutputLevel -4 Warning: Click [apply] MAY reset the ATA. apply . Cisco SYSTEMS Device Information Network …
ATA 186 and one way audio - Cisco Community
https://community.cisco.com/t5/ip-telephony-and-phones/ata-186-and-one-way-audio/td-p/1794759
I add ATA-186 SCCP to CME 8.6 infrastrukture, I can make calls and receive them but audio goes only in one direction from CME to ATA-186 . I try different calls from ATA-186 to another SCCP extension , SIP extension , SIP trunk , PSTN line same problem . I try with both phone ports on ATA-186 same result..
Now you know Ata 186 Audio Parameters
Now that you know Ata 186 Audio Parameters, we suggest that you familiarize yourself with information on similar questions.
