We have collected the most relevant information on Ata Audio Parameters. Open the URLs, which are collected below, and you will find all the info you are interested in.
ATA Passthrough Configuration - Voice Gateways
https://www.ccexpert.us/voice-gateways/ata-passthrough-configuration.html
Table 9-7 ATA AudioMode Parameter Bit Definitions; Bit Number. Definition. 0 and 16. 0/1: Disable/enable silence suppression for all audio codecs. Silence. suppression is enabled by default. Note: These bits are obsolete for SCCP loads as of ATA Release 3.0. 1 and 17. 0: Enable selected low bit rate codec in addition to G.711. This setting is the. default.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone …
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cata/186_188/3_0/english/administration/guide/sccp/sccp3_0/sccpaape.html
The Cisco ATA supports the following tone parameters: • DialTone • DialTone2 • BusyTone • ReorderTone • RingBackTone • CallWaitTone • AlertTone . The Cisco ATA supports two types of tone-parameter syntax—basic format and extended format.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone …
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cata/186_188/3_0/english/administration/guide/h323/h32330ad/h3288APE.html
Tone Configuration Parameters . The Cisco ATA supports the following tone parameters: • DialTone • BusyTone • ReorderTone • RingBackTone • CallWaitTone • AlertTone . The Cisco ATA supports two types of tone-parameter syntax—basic format and extended format.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone …
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cata/186_188/3_0/english/administration/guide/sip/sip30ad/SIP88APE.html
Two types of extended format exist for the Cisco ATA tone parameters: • Extended Format A—This format can be used for the following tone parameters: – DialTone – BusyTone – RingbackTone – CallWaitTone – AlertTone • Extended Format B—This format can be used for the following tone parameters: – ReorderTone – SITone . Extended Format A
Configuring the ATA 190 - Cisco
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cata/190/1_0/english/administration/guide/sip/ATA190/a190_ag3conf.pdf
Administration. You can set the configuration parameters using the configuration window in Table 4-2 . Note Some ATA 190 parameters are set from port 1 only. Sett ing the parameters from port 2 has no effect. Set the following parameters from port 1 only: IVR Passw ord, CDP, Impedance, Input/Output Audio Level, Timers, and Call Sequence.
How to Provision or Recover an AudioCodes ATA Adapter ...
https://support.8x8.com/equipment-devices/phones/ata-adapters/audiocodes-device-provisioning
Audiocodes purchased through 8x8 are only intended for FXS mode only.If you are using this adapter for doorbells, overhead paging systems, and other non-standard ATA devices - Please check with the manufacturer for FXS support. FXO designed devices will not work.. Please check the label of your Audiocodes ATA adapter to confirm if it has any FXO support.
Now you know Ata Audio Parameters
Now that you know Ata Audio Parameters, we suggest that you familiarize yourself with information on similar questions.
