Audio Agc Ic

Audio Compression Amplifier /AGC - ElectroSchematics.com

https://www.electroschematics.com/audio-compressor-agc/

AGC attack time & recovery time may be adjusted by altering resistor values. Signal input levels cover the range of 1.5mV to 8.3V. The output signal level is close to the consumer audio standard of -10dbV. Schematic of Audio Compression Amplifier Circuit

VERSATILE AUDIO AGC CIRCUIT - EYRG.net

http://www.g8ajn.eyrg.net/mediafire/AGC2014ArticleFull.pdf

VERSATILE AUDIO AGC CIRCUIT Dave Kenward G8AJN Whilst we spend many happy hours perfecting our video signals, the audio often tends to be an afterthought. For our local repeater a finely adjustable compressor/limiter circuit was required and this article describes what was found to be one of the most versatile solutions.

MAX9814 Microphone Amplifier with AGC and Low-Noise ...

https://www.maximintegrated.com/en/products/analog/audio/MAX9814.html

Synthesizing an Audio AGC Circuit

https://www.arrl.org/files/file/QEX_Next_Issue/Sep-Oct_2010/Anderson%20Sept-Oct.pdf

AN-1451LM4935 Automatic Gain Control (AGC) Guide

https://www.ti.com/lit/an/snaa028a/snaa028a.pdf

Automatic Gain Control - AGC Circuit - ElectroSchematics.com

https://www.electroschematics.com/automatic-gain-control-agc/

Automatic Gain Control or AGC is a circuit design which maintain the same level of amplification for sound or radio frequency. If the signal is too low the AGC circuit will increase (amplify) the level and if is to high will lower it to maintain a constant level as possible. The Automatic Gain Control principle is widely use in AM receivers and ...

Circuit Design: Automatic Gain Control - Engineers Garage

https://www.engineersgarage.com/circuit-design-automatic-gain-control/

Automatic Gain Control IC for Audio Application | All ...

https://forum.allaboutcircuits.com/threads/automatic-gain-control-ic-for-audio-application.147215/

I'm trying to find the right IC to do this, and the right way to wire it up. I was looking at the TL026C, which is an automatic gain control amp, but I'm not sure if it's suitable for an audio application. Would this be an appropriate IC to use? If so, could anyone describe how the AGC and REF OUT pins work and the right way to wire them? Thanks!