Audio Bypass Relay

ESW – True Bypass Relay Module – Aqua-Audio

https://www.aqua-audio.com/product/esw-true-bypass-relay-module/

All AQUA-AUDIO products are hand made. Specifications Operation Voltage: 8.5-12VDC, 9VDC nominal Bypass: True bypass Current draw: Mechanical Endurance: 10,000,000 Operations Electrical Endurance: 100,000 Operations (NO Contact) …

HOW TO Bypass A Relay Using One Wire!!! - YouTube

https://www.youtube.com/watch?v=aV-uAdftl7o

Classi General Purpose Relay Bypass PCB, 5,95 - don-audio.com

https://www.don-audio.com/Classi-General-Purpose-Relay-Bypass-PCB

Function: 1. Insert 12V DC coming from your device or a simple ON/OFF toggle switch to one of the LINK 2-Pin Molex connectors on... 2. Once 12V DC is off, the Relay Bypass the Signal to the XLR out, once on, the Signal goes the route to the OUT1 on the... 3. Enjoy this fine project

True Bypass Relay Module With Soft Switch - Aqua-Audio

https://www.aqua-audio.com/product/esw5-0-true-bypass-relay-module-with-soft-switch/

The ESW5.0 True Bypass module is probably the best and most reliable alternative for the standard mechanical 3PDT switch for your guitar pedals. Since the ESW5.0 True Bypass module uses a sealed signal relay, the life expectancy is much higher then a standard 3PDT switch. It can also replace the existing 3PDT switch in a pedal.

How to/should I bypass receiver relay? : audio

https://www.reddit.com/r/audio/comments/rzy0d9/how_toshould_i_bypass_receiver_relay/

True Bypass Relay with Muting – Stompville

https://stompville.co.uk/?p=423

The opto isolator function allows us to separate the control signal (from our micro-controller) and the audio signal (from our bypass relay) and in particular have separate (or managed) analogue and digital grounds. Now, we could just switch the LED on when we want to mute and this will probably work adequately in most cases.

bypass amp speaker relay - OK? — Polk Audio Forum

https://forum.polkaudio.com/discussion/134109/bypass-amp-speaker-relay-ok

July 2012 edited July 2012. The relay isn't there so much for the amp as for the speaker. Muting the output, by the relay opening, is used to avoid the transients on power up and down and to allow the circuit to stabilize before connecting to the drivers. Those snaps, crackles and pops have a fair amount of DC in them which speakers don't do to ...

Input/Output Bypass Board | waynestegall.com

http://waynestegall.com/audio/iobypass.htm

In the given circuit DUT represents the audio component which is switched in by relays X1-X4 which can be 4 SPDT or 2 DPDT relays. The relays normally connect to bypass the component when not powered up and switch to the opposite contact to connect the component with power is applied.