We have collected the most relevant information on Audio Clock Terminators. Open the URLs, which are collected below, and you will find all the info you are interested in.
Word Clock Termination - Sound Devices
https://www.sounddevices.com/word-clock-termination/
Word Clock Termination. Last updated April 2, 2019. Sound Devices' word clock connections on 7-Series recorders do not have a 75 ohm terminating impedance. We do this because several units can be connected without over-loading the unit driving it. In most situations, using no termination works just fine. However, on longer cable runs, cable ...
Understanding Digital Clocking for Audio | Sweetwater
https://www.sweetwater.com/sweetcare/articles/understanding-digital-clocking-for-audio/
Connect the BNC T-adapter to the Word Clock IN of the next device. Connect a BNC cable from the other end of the T-adapter to the end of the next T-adapter in the chain. Once your chain is completed, us a 75 Ohm BNC terminator on the very last T-adapter. Use a Master Clock to connect multiple devices in a “Chain” configuration. Click to enlarge.
Terminator-Plus
https://6moons.com/audioreview_articles/denafrips7/4/
Now the Terminator's more accurate clock controls the Avatar's or Gaia's or our Ref300D's lesser clocks. "Given a choice, it's best to have the most superior clock as close to the DAC as possible. The Plus uses native audio-frequency clocks of 45'1584MHz and 49'152MHz which by simple arithmetic—divide by 1'024—arrive at the audio frequencies of 44.1kHz and 48kHz.
Terminator-Plus
https://6moons.com/audioreview_articles/denafrips7/5/
"To activate the clock outputs, press mute. Press 'input -'. 'Clock out' lights up. Now presses on 'input -' toggle from coax (no clock) to AES1 (44.1/48kHz), AES2 (22.57/24.5MHz), OPT (45.15/49.15MHz), I²S (clock disabled, clock LED off). On Gaia's clock inputs, press setup once, press OPT twice. Clock light on. Press OPT again, clock light off.
Terminators for BNC wordclock cables? - Gearspace.com
https://gearspace.com/board/high-end/1233877-terminators-bnc-wordclock-cables.html
Many audio interfaces have wordclock termination but nowhere on the Steinberg info does it state the MR816X has it. If a device has both a wordclock input and wordclock output and there isn't an option to terminate via a physical button on the back or from the control panel software, and there's no mention of termination in the manual, it is most likely not terminated …
Now you know Audio Clock Terminators
Now that you know Audio Clock Terminators, we suggest that you familiarize yourself with information on similar questions.
