Audio Line Splitter Circuit

3 channel audio splitter - Electronic Circuits and ...

https://www.circuitstoday.com/3-channel-audio-splitter

Here the IC1 is wired as a non inverting amplifier with a gain 3.The audio signal to be splited is applied to the non inverting pin of IC1 through the …

Audio Splitter : 5 Steps - Instructables

https://www.instructables.com/Audio-Splitter/

A list of Simple audio circuits and amplifiers for DIY(Do ...

https://www.circuitstoday.com/simple-audio-circuits

none

operational amplifier - Active audio splitter (Line levels ...

https://electronics.stackexchange.com/questions/266872/active-audio-splitter-line-levels

The simplified schematic of the first stage is as follows: simulate this circuit – Schematic created using CircuitLab. The upper block is a voltage divider to form a virtual ground which is essential for single-supply opamp amplifiers so that the positive input terminal of the opamp to be greater than GND level (Although it's output can be anything between GND and …

Suggestions for Pro-Audio Line Splitter Circuit | All ...

https://forum.allaboutcircuits.com/threads/suggestions-for-pro-audio-line-splitter-circuit.13066/

The split signal will feed (2) line inputs, one will be the side chain in for a noise gate, the other into a guitar/amp modeler effects processor. If op-amps is the way to go, i guess the MXR KFK-1 EQ pedal i am using now (has two outputs) is good enough.

1 Input - 4 Outputs Stereo Audio Splitter - Electronics Area

https://electronicsarea.com/1-input-4-outputs-stereo-audio-splitter/

List of components of the 1 Input – 4 Outputs Stereo Audio Splitter. 2 LM324 or TL084 ICs (4 operational amplifiers in a single package) 8 100k resistors (R) 8 1uF / 25 volt electrolytic capacitors (C) 8 50K potentiometers (P) LM324 Quadruple Operational Amplifier Pin out. To power the circuit you need a dual polarity output power supply (+/- 12v). +12V must be …