We have collected the most relevant information on Audio Note M10 Clone. Open the URLs, which are collected below, and you will find all the info you are interested in.
Audio Note M10 Clone | diyAudio
https://www.diyaudio.com/community/threads/audio-note-m10-clone.310894/
Audio Note M10 Clone. Thread starter jerrylong; ... The M10 transformer uses a high permeability nickel iron C-core and silver windings, the core makes a huge difference to the transformer, not only sonically, but electrically as well. The material has much lower losses and far, far higher permeability, and because of the C-Core shape it’s ...
Audio Note M10 Clone | Page 11 | diyAudio
https://www.diyaudio.com/community/threads/audio-note-m10-clone.310894/page-11
Audio Note M10 Clone. Thread starter jerrylong; Start date 2017-08-08 4:28 pm; ... and then I want to make 5687 model, because I want to simulate the M10 Preamp circuit. Now I am trying to building this preamp, then I want to use the model to simulate the whole circuit, it will be convinent to use it to adjust the real circuit. ...
Audio Note M10 Clone | Page 5 | diyAudio
https://www.diyaudio.com/community/threads/audio-note-m10-clone.310894/page-5
Audio Note M10 Clone. Thread starter jerrylong; Start date 2017-08-08 4:28 pm; ... I found UK version of AN M10. The output stage is two 47k connect in parallel, fully bypassed. I sim with new value the freq response is flat down to 10hz. The riaa eq section is a little different too. If you're an owner of M10 appreciate check what version and ...
Audio Note M10 Clone | Page 3 | diyAudio
https://www.diyaudio.com/community/threads/audio-note-m10-clone.310894/page-3
Audio Note M10 Clone. Thread starter jerrylong; ... Then if you say that the declared output voltage of the M10 is 3V rms I really doubt the TURN ratio is 33:1. I said at the beginining this more likely the impedance ratio because, without taking losses into account, the 5687 should already provide 99V rms at the primary which is simply ...
Audio Note M10 Clone | Page 12 | diyAudio
https://www.diyaudio.com/community/threads/audio-note-m10-clone.310894/page-12
Audio Note M10 Clone. Thread starter jerrylong; ... My friend has made a 6.5K:600 OPT, it is finished today. I put them on, it is quite good, till now the clone job of M10 is finished, it sound very good. then I will use LT-SPICE to test it and compare with the real circuit. If there is any thing to improve I will go on.
Now you know Audio Note M10 Clone
Now that you know Audio Note M10 Clone, we suggest that you familiarize yourself with information on similar questions.
