We have collected the most relevant information on Audio Receiver Turns Off At High Volume. Open the URLs, which are collected below, and you will find all the info you are interested in.
receiver shuts off when turned up | Audioholics Home ...
https://forums.audioholics.com/forums/threads/receiver-shuts-off-when-turned-up.4049/#:~:text=If%20your%20speakers%20are%206%20or%204%20ohms,not%20rated%20at%208%20ohms%20to%20shut%20down.
Receiver Shutting off at High Volume | AVS Forum
https://www.avsforum.com/threads/receiver-shutting-off-at-high-volume.2537953/
Just replace the speakers wire instead, and when you plug them in, this is very important, make sure that the copper on the wire isn't touching another one at all. Replace the speakers wire fist, and if you still get problems, then it's just the receiver being push too much. Is there a reason why you play it so it high?
Stereo shutting off at high volume - Tom's Guide Forum
https://forums.tomsguide.com/threads/stereo-shutting-off-at-high-volume.97567/
Jan 16, 2016. #1. Well here it goes.shuts down after a point when it gets to crazy levels. So what I have is a Yamaha RX-V465 AV Receiver 525 watt (105w x5) I HAD a practically new pair of Polk Monitor 70 series 2 Tower speakers which were rated at 275w, I sold them last week. I have a Bose center speaker which I’m not sure of the watts.
SOLVED! - Speakers Cutting Out at High Volume
https://www.musictoob.com/speakers-cutting-out-at-high-volume-heres-the-fix/
Well, according to some technicians, the first reason is the most common culprit because of which the speakers tend to cut off at high volume levels. In order to fix it, you will need to disconnect all the wires from the output of the amplifier which connects it to the speaker.
Why does my unit shut off at 1/4 volume or less ? - Yamaha ...
https://usa.yamaha.com/support/faq/audio_visual/2438.html
Disconnect all of the speaker wires from the back of the receiver. Turn the receiver on, and turn the volume control up to about half way. If the receiver stays on, please go to Step 3. If the receiver shuts off right away, the unit will require service. Please consult with your dealer for further assistance.
receiver shuts off when turned up | Audioholics Home ...
https://forums.audioholics.com/forums/threads/receiver-shuts-off-when-turned-up.4049/
If your speakers are 6 or 4 ohms your receiver is going to shut down at high volumes to protect itself. Even if your speakers are 8 ohms they may dip at certain frequencies which may also shut your receiver down if played at a high volume for long enough. Sometimes it will only take one or two speakers that are not rated at 8 ohms to shut down.
Reciever Turns Off During Loud Volumes | Home Theater Forum
https://www.hometheaterforum.com/community/threads/reciever-turns-off-during-loud-volumes.11101/
Most Kenwood receivers are rated for 6 ohm speakers. If you happen to be running 4 ohm speakers (or lower), the impedance level is dropping too low for your receiver to handle at high volumes. If you let this go for too long, you'll be taking that receiver in for a service call down the road a bit. Sep 18, 2001 #4 of 13 Ted Lee Senior HTF Member
New Denon AVR1613 cuts out at high volume - Home Theater …
https://www.hometheaterforum.com/community/threads/new-denon-avr1613-cuts-out-at-high-volume.319328/
We've just replaced our ailing receiver with a brand new Denon AVR1613. The sound is great using surround sound (5 speakers and a subwoofer), however in putting it through its paces we've found that the protection circuit activates--shutting down the amp--whenever volume gets high during a loud movie. Typically the volume is set at about 68 during these times.
Sound Cutting Out at High Volumes | DiyMobileAudio.com Car ...
https://www.diymobileaudio.com/threads/sound-cutting-out-at-high-volumes.83465/
When turning up the volume on a song, the components started cutting out. I messed with the gains, the high pass filters, etc, and noticed it only cuts out during particularly bassy parts of the song (sub which uses a different amp wasn't cutting out btw), so obviously it's an issue with the speakers drawing too much power.
Reciever keeps shutting down at loud volumes (but I'm ...
https://www.stereophile.com/content/reciever-keeps-shutting-down-loud-volumes-im-using-monoblocks-1
If this doesn't solve the problem, unplug everything except a source and try to get the receiver itself to shut down. Yep, if you want really loud, the Polks are a poor choice. You need some thing about 10dB higher in electrical sensitivity. Klipsch and JBL are two mass market brands that have higher sensitivity.
Audio System Turns off by Itself | Sony USA
https://www.sony.com/electronics/support/articles/00032091
Remove all connected components. If resolved, then one of the previously connected components is causing the issue. To determine what device is faulty, reconnect each component one at a time to your device. Turn off Sleep mode. If the AUTO.STBY is set to ON, change the setting to STBY OFF or OFF. If the issue still occurs, repair may be required.
Now you know Audio Receiver Turns Off At High Volume
Now that you know Audio Receiver Turns Off At High Volume, we suggest that you familiarize yourself with information on similar questions.
