We have collected the most relevant information on Audio Sector Chip Amp. Open the URLs, which are collected below, and you will find all the info you are interested in.
Audiosector
Audiosector. The purpose of audio is the communication of the original musical inspiration rather than simply obtaining impressive measurement results. In our creations, we stress accurate reproduction of low level information and immediacy, as those are major factors that allow components to sound natural, musical and complete, in contrast to ...
AudioSector-chip amp kits, dacs, chassis | diyAudio
https://www.diyaudio.com/community/threads/audiosector-chip-amp-kits-dacs-chassis.51381/
Those who like well implemented chip amps, should definitely enjoy this DAC as well. I decided to keep things simple with regards to assembly, so the whole DAC is contained on a single board. With 48VA Hammond trafo, dual raw supplies, common mode chokes and resistors for CLRC filtering, the PS is less simple, but it compares very favourable ...
AudioSector-chip amp kits, dacs, chassis | Page 2 | diyAudio
https://www.diyaudio.com/community/threads/audiosector-chip-amp-kits-dacs-chassis.51381/page-2
The diodes are almost $2/pc in 100pc quantities, which was quite surprising, considering much lower cost of MUR860. There will be a scoring line, that can separate PS section from the actual DAC circuit. As you see, the PS takes 2/3rds of the board area. The width allows fitting it inside 2 x 3 aluminum square tubing.
AudioSector-chip amp kits, dacs, chassis | Page 53 | diyAudio
https://www.diyaudio.com/community/threads/audiosector-chip-amp-kits-dacs-chassis.51381/page-53
HI I just rewierd the power supply in the gainclone . I went to the Brian's page and I look up the gallery . I found a similar gainclone like mine , with two transformer ect . I saw in that gainclone the power supply was hock up diferent way …
AudioSector-chip amp kits, dacs, chassis | Page 25 | diyAudio
https://www.diyaudio.com/community/threads/audiosector-chip-amp-kits-dacs-chassis.51381/page-25
I was using for at least 2 months LM4780 amp in stereo configuration then I switched to bridged setup (same chip) and I liked them both. It is a matter of deeper refinement and it is not always that obvious and greatly depends on the rest of the system.
DIY LM3875 Chip Amplifier (Gainclone) Kit - DIY AUDIO …
https://diyaudioprojects.com/Chip/Beast/
The amp is one of those rare pieces of audio gear that acted much like a wire that amplified. It had flat response from DC to 100 kHz. 100 kHz square waves were pretty square with only mild rounding of the leading edge. Noise was below the resolution of the scope. My ears said something in the order of -90 dB.
Now you know Audio Sector Chip Amp
Now that you know Audio Sector Chip Amp, we suggest that you familiarize yourself with information on similar questions.
