We have collected the most relevant information on Audiocodes Cannot Find Endpoint For Phone Number. Open the URLs, which are collected below, and you will find all the info you are interested in.
Lync Server installation with pstn and audiocodes mp114
https://social.technet.microsoft.com/forums/lync/en-US/68acc858-6cb9-4e1e-8ce7-880e2180a3e5/lync-server-installation-with-pstn-and-audiocodes-mp114
"can't find endpoint for phone number" is a common error when you do not define endpoint phone number, I have a .ini to share if you want. You have to define number of lines connected and phone numbers (you can put a "1000") on endpoint phone number section of audiocodes configuration. Example 1-4 1000 Hope it helps Monday, June 27, 2011 3:54 PM 0
Configuration Note - AudioCodes
https://www.audiocodes.com/media/10181/ltrt-31902-audiocodes-mediant-1000-msbg-with-microsoft-lync-and-verizon-sip-trunk-configuration-note.pdf
A.1 Step 1: Configure the Endpoint Phone Number Table..... 97 A.2 Step 2: Configure Tel to IP Routing Table..... 98 A.3 Step 3: Configure Coders Table..... 99
Problems with AudioCodes MP-114 - 3CX Forums
https://www.3cx.com/community/threads/problems-with-audiocodes-mp-114.2934/
On the AudioCodes device I am getting the following in the Message Log: Log is Activated 6d:16h:18m:26s ( lgr_TrnkGrp)(35 ) !! [ERROR] #1:TrunkGroup::AllocateEndPoint- Can't find EndPoint for phone number 1518XXXXXXX [Time: 16:18:26] 6d:16h:18m:26s ( lgr_psbrdif)(36 ) !! [ERROR] MotherBoard::GetEndPoint- Can't find EndPoint for Dest:1518XXXXXXX
AudioCodes MP-102/104/108 - net2phone
https://partner.net2phone.com/partnersupport/products/audiocodesmp/audiocodesmpconfigguide.pdf
1. Click Protocol Management on the left, and click Endpoint Phone Numbers. Endpoint Phone Number Table 2. In the Channel(s) and Phone Number columns, enter the following values, depending on whether you have outbound only or inbound/outbound service. For example, Channel 1 could have the following settings: Service Type Field Display Name Value Channel(s) …
Paging from Lync through AudioCodes gateway - VoIP Forum ...
https://community.spiceworks.com/topic/1957897-paging-from-lync-through-audiocodes-gateway
Text. TrunkGroup::AllocateEndPoint- Can't find EndPoint for phone number +260. When I dial 260 it rings once and then I get a fast busy and then it disconnects. The paging system is connected through the first FXO interface. I'm lost as to how to setup the configuration on the AudioCodes gateway.
Audiocodes setup manual - Zadarma
https://zadarma.com/en/support/instructions/audiocodes/
Open VoIP – GW and IP to IP – Hunt Group Setting, Set ID Hunt Group, Channel mode – strategy by which lines will be chosen and in our case Registration mode – per endpoint Click Submit In this section open tab Endpoint Phone Number and set on Hunt a group of number. Click Submit 6. Set routes for calls from IP on analog ports and vice versa.
Now you know Audiocodes Cannot Find Endpoint For Phone Number
Now that you know Audiocodes Cannot Find Endpoint For Phone Number, we suggest that you familiarize yourself with information on similar questions.
