We have collected the most relevant information on Audiocodes Error. Open the URLs, which are collected below, and you will find all the info you are interested in.
CPE Troubleshooting Guide - AudioCodes
https://www.audiocodes.com/media/10408/ltrt-57601-cpe-sip-troubleshooting-guide.pdf
This document provides troubleshooting procedures for AudioCodes customer premises equipment (CPE), Voice-over-IP (VoIP) media gateway devices. Information contained in this document is believed to be accurate and reliable at the time of printing. However, due to ongoing product improvements and revisions, AudioCodes cannot
Audio Codes SBC giving error " failed sending message with ...
https://social.microsoft.com/Forums/Azure/en-US/fa96bd9c-ca54-4209-9f5d-d8a7789b6323/audio-codes-sbc-giving-error-quot-failed-sending-message-with-cseq-1-options-the-cause-is
It recommends you try to check if you meet these pre-requisites in AudioCodes SBC. *AudioCodes SBC should running at least version 7.20A.250 or above *SBC Sessions and Microsoft Teams license should be installed *Make sure you allow the following ports that the SBC uses. For more details about detailed pre-requistes in SBC, you can refer to:
Audiocodes SBC ERROR failed parsing Outgoing SIP. …
https://github.com/sipcapture/paStash/issues/76
Hi, tried the paStash with Audiocodes SBC thing to get syslogs to Homer, but no luck so far. When I redirect the syslog from Audiocodes Mediant SW SBC to paStash IP, I see the traffic incoming and at the same time massive amount of ERROR...
Teams call transfer failed - Audiocodes VE - Microsoft ...
https://techcommunity.microsoft.com/t5/microsoft-teams/teams-call-transfer-failed-audiocodes-ve/td-p/1166532
Teams call transfer failed - Audiocodes VE. I have setup an Audiocodes VE Direct Routing SBC, but during the tests I noted that I was not able to forward calls. As I can see, during the REFER process there is a 488 Not Acceptable answer, because of media mismatch between the Mediant and the O365. The p2p calls are working properly in every ...
Transcoding issue on the Audiocodes Mediant-Sharing ...
https://erwinbierens.com/audiocodes-mediant-transcoding-issue/
Tried to switch to “Optimized for SIP”, reboot and change back. This didn’t do the trick. You can find this setting over here: Setup > Signaling & media > SBC > SBC General Settings. I checked the VMware specs with the people from infra. You can check this also on the Audiocodes SBC CLI (SSH) with the following command (Thanks to Jurgen ...
Now you know Audiocodes Error
Now that you know Audiocodes Error, we suggest that you familiarize yourself with information on similar questions.
