We have collected the most relevant information on Audiocodes Gateway Default Password. Open the URLs, which are collected below, and you will find all the info you are interested in.


AudioCodes MP114/118 (Pulse) - Zenitel Wiki

    https://wiki.zenitel.com/wiki/AudioCodes_MP114/118_(Pulse)#:~:text=The%20AudioCodes%20MP-114%2F118%20VoIP%20Gateway%20comes%20with%20default,%28username%3A%20Admin%2C%20password%3A%20Admin%29%20by%20following%20these%20steps%3A
    none

CLI Wizard Utility User's Guide - AudioCodes

    https://www.audiocodes.com/media/14313/cli-wizard-utility-users-guide.pdf
    Type the username(default is case sensitive Admin-), and then press Enter; the wizard prompts you for the password: Welcome to AudioCodes CLI Username: Admin Password: 4. Type the login password (default is casesensitive- Admin), and then press Enter; you have now accessed the device's embedded CLI server: > 5.

Mediant™ 1000B Gateway & E-SBC - AudioCodes

    https://www.audiocodes.com/media/13746/mediant-1000b-gateway-e-sbc-quick-guide.pdf
    Type in the default username (Admin) and password (Admin), and then click Log In. 5. Open the IP Interfaces table ( Setup menu > IP …

AudioCodes MP114/118 (Pulse) - Zenitel Wiki

    https://wiki.zenitel.com/wiki/AudioCodes_MP114/118_(Pulse)
    Load Factory Default values. Disconnect the Ethernet cable from the device. With a paper clip or any other similar pointed object, press and hold down the Reset button (located on the rear panel) for about six seconds. Release the Reset button. The …

User’s Manual - AudioCodes

    https://www.audiocodes.com/media/10471/ltrt-83310-mediant-600-and-mediant-1000-sip-users-manual-v64.pdf
    Mediant™ 600 & Mediant™ 1000 VoIP Media Gateways SIP Protocol User’s Manual Version 6.4 March 2012 Document # LTRT-83310

User's Manual - AudioCodes

    https://www.audiocodes.com/media/10460/ltrt-71405-mgcp-megaco-mediapack-series-users-manual-ver-66.pdf
    Version 6.6 . June 2014 . Document # LTRT-71405 . User's Manual . MP-1xx & MP-124 . MediaPack™ Series . Analog VoIP Media Gateways . MGCP & MEGACO Protocols

Mediant™ 800 Gateway and E-SBC - AudioCodes

    https://www.audiocodes.com/media/13726/mediant-800-gateway-e-sbc-quick-guide.pdf
    1 | Page Mediant™ 800 Gateway and E-SBC Quick Setup Guide Welcome Congratulations on purchasing your AudioCodes Mediant 800 Gateway and Enterprise Session Border Controller (E-SBC), hereafter, referred to as the device!This Quick Guide applies to hardware revisions B and C. This document is intended to provide basic setup instructions for …

AudioCodes Mediant 1000 - Zenitel Wiki

    https://wiki.zenitel.com/wiki/AudioCodes_Mediant_1000
    Load factory network parameters and reset the username and password to its default settings (username: Admin, password: Admin) by pressing the reset button located to the right of ethernet port II, and directly above the RS-232 port, labeled // for minimum 6 seconds. The VoIP Gateway will now get the IP address 192.168.0.2, submask 255.255.255.0.

Now you know Audiocodes Gateway Default Password

Now that you know Audiocodes Gateway Default Password, we suggest that you familiarize yourself with information on similar questions.