We have collected the most relevant information on Audiocodes Reset To Factory Defaults. Open the URLs, which are collected below, and you will find all the info you are interested in.
Reset an AudioCodes Phone – Olafe
https://support.olafe.com/hc/en-us/articles/234574068-Reset-an-AudioCodes-Phone#:~:text=Reset%20an%20AudioCodes%20Phone%201%20In%20the%20phone%27s,Yes%20soft%20key%20to%20confirm%20reset%20to%20defaults.
IP Phone: Restoring Phone to Factory Defaults - …
https://www.audiocodes.com/media/14547/audiocodes-quick-reference-guide-restoring-ip-phone-to-factory-defaults.pdf
To restore the phone’s factory defaults using the phones screen: Press the Menu key. Scroll down to Administration and press OK. Enter the Admin password (default 1234) followed by OK. Scroll down to Restore Defaults and press OK. A warning screen will …
How to Factory Reset a AudioCodes Mediant 1000 E-SBC with ...
https://myworldofit.net/?p=6801
Push and hold the button inside there down for roughly 10 seconds and you will see the fourth network port status light turn red to indicate something interesting is happening. After 10 seconds let go of the button and give the E-SBC time to reboot and restore its settings to factory default (I have found about 8 minutes should be enough time).
Factory Reset Audiocodes Mediapack 112 by Shell …
https://erwinbierens.com/factory-reset-audiocodes-mediapack-112-by-shell/
Go the the webinterface (System, Management, Telnet/SSH Settings) and enable SSH access. Use PuTTy to connect to the current IP Address of the MediaPack. Use the default credentials if not changed: Admin - Admin Type “Conf” to enter the configuration menu. Type “RestoreFactorySettings” to Restore the MediaPack to factory default settings.
AudioCodes™
https://www.audiocodes.com/media/2504/ltrt-32301-mp-20x-frequently-asked-questions.pdf
AudioCodes Customer Support Page 10 Default Configuration Q1: How do I restore MP-20x to factory default settings? A: You can restore MP-20x to default settings using one of the following methods: Web interface: a) Logon to the Web interface. b) Access the ‘Restore Defaults’ screen (Advanced menu > Restore Defaults icon). c) Click OK.
CLI Wizard Utility User's Guide - AudioCodes
https://www.audiocodes.com/media/14313/cli-wizard-utility-users-guide.pdf
To restore the device to factory defaults: 1. At the #prompt, type write factory, and then press Enter; the device starts the restoringto-factory - defaults process. This may take a few minutes. # write factory Writing factory default and restarting … 2. When the device has restored to factory defaults, you are prompted again to log in to the CLI. 3.
Now you know Audiocodes Reset To Factory Defaults
Now that you know Audiocodes Reset To Factory Defaults, we suggest that you familiarize yourself with information on similar questions.
