We have collected the most relevant information on Audiocontrol Lc2i Amplifier. Open the URLs, which are collected below, and you will find all the info you are interested in.
LC2i - AudioControl
https://www.audiocontrol.com/car-audio/factory-system-upgrade/lc2i/
The LC2i, is a compact, two-channel processor with active input circuitry, which allows it to accept speaker-level signals of up to 400 watts per channel from factory-installed source units or amplifiers. It converts them to high-quality pre …
LC2i PRO - AudioControl
https://www.audiocontrol.com/car-audio/factory-system-upgrade/lc2i-pro/
The LC2i PRO join ranks with AudioControl’s most popular active line output converter, the LC2i. Adding a sub? Planning a full system? Either way, get the …
LC2i User Manual - Home | AudioControl
https://www.audiocontrol.com/downloads/car/current/lc2i/lc2i-user-manual.pdf
the factory audio system the LC2i will power up as well. After the LC2i turns on, it provides a 12 volt trigger output to turn on your amplifier. A Jumper which you can reach from the end panel allows you to set this feature on/off for specialized installations. The factory default setting for the GTO™ circuit is always ON.
Amazon.com: AudioControl LC2i 2 Channel Line Out …
https://www.amazon.com/AudioControl-Channel-Converter-AccuBASS-Subwoofer/dp/B00IIL0LW0
How to power and turn on the LC2i - AudioControl
https://www.audiocontrol.com/knowledge-base/how-to-power-and-turn-on-the-lc2i/
The GTO operates in the same fashion for the LC2i. Once a carrier signal is detected on the ‘Left Speaker Input,’ the unit will turn on and begin sending audio signal to the designated amp. The unit is shipped with the GTO jumper set to ‘Enabled’.
AudioControl LC2i at Onlinecarstereo.com
https://www.onlinecarstereo.com/CarAudio/p_28505_AudioControl_LC2i.aspx
AudioControl LC2i Line Out Converter If you’re upgrading amps but want to keep your factory receiver, the LC2 AudioControl will make it a smooth transition. Adding this device to a sound system allows the user to convert two speaker-level outputs into RCA pre-amp outputs, which is often needed when connecting a new amplifier to an OEM stereo.
Amazon.com: AudioControl LC2i PRO 2-Channel Line …
https://www.amazon.com/AudioControl-2-Channel-Output-Converter-Speakers/dp/B09HL3RT6G
AudioControl LC2i PRO 2-Channel Line Output Converter with Impedance Matching, AccuBASS, GTO, Audio Signal Sense, 12V Turn-On and ACR-1 Dash Remote Subwoofer Control 4.7 out of 5 stars 471 23 offers from $109.95
How to setup AccuBASS on the LC2i - AudioControl
https://www.audiocontrol.com/knowledge-base/how-do-i-set-accubass/
On the LC2i, the Threshold knob (screw) is located on the side of the unit between the Main and Bass RCA output connectors. A micro screwdriver will be needed in order to adjust it. It’s also good to note that the Bass knob on the LC2i is for setting the output gain (level) of the Bass output. It does not have anything to do with the AccuBASS ...
How do I set the output gains on my line ... - AudioControl
https://www.audiocontrol.com/knowledge-base/set-levels-line-converterprocessoreqcrossover/
When setting the output gain levels on our line converters (LC2i, LC6i, LC7i, LC8i, LCQ-1 etc…) our goal is to match the gain output, with the gain input sensitivity of your aftermarket amplifier. The idea is to send the hottest signal possible out of the converter, without distorting the output of the converter, and also […]
How do I connect Audiocontrol lc2i to the factory head ...
https://www.caraudio.com/threads/how-do-i-connect-audiocontrol-lc2i-to-the-factory-head-unit.568008/
I have two subwoofers and amplifier. I have installed the power wire, ground wire, and remote wire. Since I am keeping my factory head unit, I have bought LOC ( a high to low adaptor), Audiocontrol lc2i. The problem i am having is I do not know how to connect LOC(audiocontrol lc2i) to the facotry head unit or rear speakers.
Now you know Audiocontrol Lc2i Amplifier
Now that you know Audiocontrol Lc2i Amplifier, we suggest that you familiarize yourself with information on similar questions.
