We have collected the most relevant information on C-Audio Sr606 Bridge. Open the URLs, which are collected below, and you will find all the info you are interested in.
C-audio SR606 Power Amplifier | diyAudio
https://www.diyaudio.com/community/threads/c-audio-sr606-power-amplifier.76909/
C-Audio SR606 The problem is that the large 47 Ohm resistor in series with 230V primary has blown, I think this resistor should be 10 Ohm as I have seen in other BIG amplifiers , this is a BIG amplifier with a Big toroidal transformer. ... Second if the amplifier has a short somewhere most common is the bridge rectifiers.
C-Audio SR606 Stereo Power Amplifier Manual | HiFi Engine
https://www.hifiengine.com/manual_library/c-audio/sr606.shtml
Manual Library / C-Audio. C-Audio SR606. Stereo Power Amplifier (1999) add a review. Specifications. Power output: 390 watts per channel into 8Ω (stereo), 1300 watts into 8Ω (mono) Frequency response: 5Hz to 50kHz. Total harmonic distortion: 0.05%. Damping factor: 500. Signal to noise ratio: 100dB.
c-audio sr606 and sr808 power amps - diyAudio
https://www.diyaudio.com/forums/solid-state/142240-audio-sr606-sr808-power-amps.html
c-audio sr606 and sr808 power amps. my sr606 is running in bridge mode, left side, and it buzzes. my 808 is also running in bridge mode and it's quiet. could something be wrong with the 606? is it a ground problem? when i bought the amps they were in a rack and both amps had a 1 foot 12 gauge ground wire hooked to the chassis, i can't recall ...
C-audio SR606 in Protect & burning out speakers ...
https://forum.speakerplans.com/caudio-sr606-in-protect-burning-out-speakers_topic49863.html
I have 3 of these amps, all of which have been happily running 4R bridge on sub duty for many years now, yeah they get a bit warm but what c audio amp doesn't 2 of them have never failed. But this one has, i just want to know where to look first for problems or if anyone on here has had the same problem.
SCHEMATICS FOR C-AUDIO SR606 AND 707 | Tom's Guide Forum
https://forums.tomsguide.com/threads/schematics-for-c-audio-sr606-and-707.236930/
I've got 2 c-audio power amp. 1 c-audio sr404 fully upgraded to a sr707, and 1 sr606. Both of them are now not working, and i'm searching for schematics to recover them. Can you help me? Thanks a lot, Maurizio
C-Audio SR707 Stereo Power Amplifier Manual | HiFi Engine
https://www.hifiengine.com/manual_library/c-audio/sr707.shtml
Power output: 488 watts per channel into 8Ω (stereo), 1653 watts into 8Ω (mono) Frequency response: 5Hz to 50kHz. Total harmonic distortion: 0.05%. Damping factor: 700. Signal to noise ratio: 100dB. Speaker load impedance: 2Ω (minimum) Dimensions: 482 x 133 x …
Now you know C-Audio Sr606 Bridge
Now that you know C-Audio Sr606 Bridge, we suggest that you familiarize yourself with information on similar questions.
