We have collected the most relevant information on Cisco Cube Sip To H323 No Audio. Open the URLs, which are collected below, and you will find all the info you are interested in.
incoming sip call with no audio drop after 10 seconds - Cisco
https://community.cisco.com/t5/ip-telephony-and-phones/incoming-sip-call-with-no-audio-drop-after-10-seconds/td-p/2158090
1. We changed the integration from cucm--h323--cube--sip--ITSP TO cucm--sip--cube--sip--ITSP. 2. We removed the bind commands on the gateway because you are using different interfaces to connect to the LAN and your ITSP. 3. We configured the SIP trunk IP address to the IP address that the CUBE chose as the closest destination amongst all the ...
H.323-to-SIP Interworking on CUBE - Cisco
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book/h323-to-sip.pdf
AlertwithPI=0 180Ring SIP/SCCPphoneatTGW Configuring H.323-to-SIP Interworking SUMMARYSTEPS 1. enable 2. configure terminal 3. voice service voip 4. allow-connections h.323 to sip 5. allow-connections sip to h.323 H.323-to-SIPInterworkingonCUBE 5 H.323-to-SIPInterworkingonCUBE H.323-to-SIPCodecProgressIndicatorInterworkingforMediaCut-Through
Solved: CUBE - One way audio - Cisco Community
https://community.cisco.com/t5/unified-communications/cube-one-way-audio/td-p/4432836
CUBE - One way audio. We are facing one way audio connecting to a SIP provider. Callee cant hear the voice of caller, the other way is fine. I can see rx and tx packets increasing during the call. Provider had confirmed that they are not receiving any RTP and to check internally. Attached is the config of VGW. Appreciate for any input.
How to troubleshoot one-way / no audio issues - Cisco ...
https://community.cisco.com/t5/collaboration-voice-and-video/how-to-troubleshoot-one-way-no-audio-issues/ta-p/3164442
How to check really quick if the phones are sending / receiving RTP (audio). * Open the web page for 2 test phones, then click the 'stream 1' link located at the left handed side of the page, and check if the IP address and port match the information on both sides, keep pressing the 'stream 1' link and you will notice that the Tx and Rx stats ...
CUBE- one way audio intermittent for inbound calls - Cisco ...
https://community.cisco.com/t5/ip-telephony-and-phones/cube-one-way-audio-intermittent-for-inbound-calls/td-p/2397872
Have a CUBE on 3800 with 15.14M(6) with SIP to SIP dial peers. Some external inbound callers at times can hear no audio streaming from IVR. I run a traffic capture from the LAN side of the CUBE and I can hear the audio. I run a traffic capture on the WAN side (towards caller) and i hear nothing, BUT the rtp stream is active (50 pps G711a).
Cisco Unified Border Element Configuration Guide …
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book/voi-audio-forced.html
H.323-to-SIP Interworking on CUBE; H.323-to-H.323 Interworking on CUBE; SIP RFC 2782 Compliance with DNS SRV Queries; Support for SRTP. SRTP-SRTP Interworking; SRTP-RTP Interworking; SRTP-SRTP Pass-Through; High Availability. High Availability on Cisco 4000 Series ISR and Cisco Catalyst 8000 Series Edge Platforms
Now you know Cisco Cube Sip To H323 No Audio
Now that you know Cisco Cube Sip To H323 No Audio, we suggest that you familiarize yourself with information on similar questions.
