Cisco Protocol Rtp Audio

Understanding RTP and RTCP - Voice Config - Cisco ...

https://www.ccexpert.us/voice-config/understanding-rtp-and-rtcp.html#:~:text=You%20can%20use%20RTP%20for%20audio%20or%20video,Keep%20in%20mind%20that%20RTP%20streams%20are%20one-way.

none

protocol rtp audio port range - Cisco Community

https://community.cisco.com/t5/other-collaboration-subjects/protocol-rtp-audio-port-range/td-p/598311

04-24-2006 04:08 AM. protocol rtp audio port range. Hi. Which port range is covered by "protocol rtp audio" is it: 1.range 16384 32764 …

RTP - Cisco Community

https://community.cisco.com/t5/collaboration-voice-and-video/rtp/ta-p/3113486

Configure Real-time Transport Protocol (RTP ... - Cisco

https://www.cisco.com/c/en/us/support/docs/smb/unified-communications/cisco-small-business-spa300-series-ip-phones/smb3331-configure-real-time-transport-protocol-rtp-parameters-on-spa.html

Configuring SIP Support for SRTP - Cisco

https://www.cisco.com/c/en/us/td/docs/ios/voice/sip/configuration/guide/12_4t/sip_12_4t_book/sip_cg-srtp.pdf

Classifying Network Traffic Using NBAR in Cisco IOS XE ...

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/qos_nbar/configuration/xe-3s/Classifying_Network_Traffic_Using_NBAR_in_Cisco_IOS_XE_Software.html

QoS: NBAR Configuration Guide - Cisco

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/qos_nbar/configuration/xe-16/qos-nbar-xe-16-book/clsfy-traffic-nbar.html

Understanding RTP and RTCP - Voice Config - Cisco ...

https://www.ccexpert.us/voice-config/understanding-rtp-and-rtcp.html

As the devices establish the call, the RTP audio streams use an even UDP port from 16,384 to 32,767, as previously discussed in this section. RTCP creates a separate session over UDP between the two devices by using an odd-numbered port from the same range. Throughout the call duration, the devices send RTCP packets at least once every 5 seconds.

How RTP (Real-time Transport Protocol ) Works in VOIP ...

https://www.pbxdom.com/blog/engineering/how-rtp-real-time-transport-protocol-works-in-voips

The Real-Time Transfer Protocol with the acronym RTP was standardized in 1996. It allows the transmission of audio and video data in real-time. RTP has end-to-end transport capabilities for real-time applications on multicast or unicast network services. Thus, it is widely used for interactive audio and video conferencing.

Cisco IOS Commands to Configure NBAR - ONT - Cisco ...

https://www.ccexpert.us/ont/cisco-ios-commands-to-configure-nbar.html

RTP has a control protocol sister called Real-Time Protocol Control Protocol (RTCP). Whereas RTP uses the UDP even-numbered ports (starting with 16384 by default), RTCP uses the UDP odd-number ports. NBAR deep packet inspection allows you to do classification based on RTP payload type (audio or video) or do a deeper classification based on audio or …