We have collected the most relevant information on Controlling Pulseaudio Command Line. Open the URLs, which are collected below, and you will find all the info you are interested in.
Controlling PulseAudio from the Command Line - Shallow …
https://shallowsky.com/linux/pulseaudio-command-line.html
Controlling PulseAudio from the Command Line Controlling PulseAudio via pavucontrol is all very nice, but it's time consuming and fiddly: you have to do a lot of clicking in a lot of tabs any time you want to change anything.
How to control your Pulseaudio sound volume using the ...
https://securitronlinux.com/debian-testing/how-to-control-your-pulseaudio-sound-volume-using-the-command-line/
Pulseaudio can easily be controlled with the command line. The pactl utility is used to control the sound volume of a Pulseaudio sink. List all sinks with this command. jason@jason-desktop:~$ pactl list sinks Then look through the list to see which is the device you wish to control, then use this command to increase the sound volume.
PulseAudio from the Command Line (Shallow Thoughts)
https://shallowsky.com/blog/linux/pulseaudio-cmdline.html
PulseAudio from the Command Line Controlling PulseAudio from the Command Line #tags linux,audio,pulseaudio,ubuntu,cmdline Controlling PulseAudio via pavucontrol is all very nice, but it's time consuming and fiddly: you have to do a lot of clicking in a lot of tabs any time you want to change anything.. So I've been learning how to control PulseAudio from the …
pulseaudio - How can I control pavucontrol in command line ...
https://unix.stackexchange.com/questions/527422/how-can-i-control-pavucontrol-in-command-line
You can control Pulseaudio with pavucontrol, or you can control Pulseaudio with pactl (or pacmd ). pactl has a limited set of commands, pacmd follows the general CLI syntax (see man 5 pulse-cli-syntax or do pacmd --help ). Changing "Analog Stereo Output" is IIRC done by changing the profiles, see set-card-profile.
pulseaudio - How to control equalizer within command …
https://unix.stackexchange.com/questions/164476/how-to-control-equalizer-within-command-line
The script uses the amplification coefficients of the smallest and largest frequencies specified on the command line, for the frequencies below and above these, respectively, so in this case the whole spectrum will be assigned an amplification rate of 1.0. At this setting, the equalizer will leave the signal unchanged (in theory at least).
Now you know Controlling Pulseaudio Command Line
Now that you know Controlling Pulseaudio Command Line, we suggest that you familiarize yourself with information on similar questions.
