Diyaudio Collaborative Tapped Horn Project

We have collected the most relevant information on Diyaudio Collaborative Tapped Horn Project. Open the URLs, which are collected below, and you will find all the info you are interested in.

Collaborative Tapped horn project - diyAudio

https://www.diyaudio.com/community/threads/collaborative-tapped-horn-project.97674/

A tapped horn such as this is a 1/4 wave horn at 18 Hz which is what hornresp shows, but at the same time it is a 1/2 wave horn at 36 Hz. This is what hornresp doesn't show. With the correct driver, the result is that the response is flat and the dips are filled in. The tapped horn has only one driver while the other horn has two.

Collaborative Tapped horn project | Page 115 | diyAudio

https://www.diyaudio.com/community/threads/collaborative-tapped-horn-project.97674/page-115

Recently I built a bandpass sub, and much to my surprise, it seemed louder than my tapped horn. Even though the tapped horn was bigger, and used the same driver. This was quite a shock, so I researched things, and I think I've solved the mystery. The problem is that almost everyone is...

Collaborative Tapped horn project | Page 48 | diyAudio

https://www.diyaudio.com/community/threads/collaborative-tapped-horn-project.97674/page-48

Re: Failed at modeling in AkaBak XJ-15 Parameters: Greets! A quick sim yielded a 1222+L box for a 18.2-72.8 Hz alignment and with a dual driver isobaric 'only' 898+L, so wouldn't be my first choice in a tapped horn. Even a single driver tapped pipe …

Collaborative Tapped horn project | Page 45 | diyAudio

https://www.diyaudio.com/community/threads/collaborative-tapped-horn-project.97674/page-45

Featured Vendors The diyAudio Store Parts Connexion miniDSP DIY HiFi Supply. ... Collaborative Tapped horn project. ... 54.92 Hz we're looking at a large 'one note' boombox if either a tapped pipe or conic horn and when I shift 'Fl' up to 14 Hz I wind up with ~122 dB from ~18-50 Hz if a 14 Hz expo flare is used, but it's a whopping ~345.3 ft^3! ...

Collaborative Tapped horn project | Page 9 | diyAudio

https://www.diyaudio.com/community/threads/collaborative-tapped-horn-project.97674/page-9

One thing I have found when simulating the tapped horn in hornresp is that most prodrivers have way to low mass to be any usefull. I think even the Eminence LAB 12 driver has to weak motorsystem and too low mass. I just simulated a huge tapped horn with two Ciare 18.00 SW driver in an isobaric configuration. (face to face).

Now you know Diyaudio Collaborative Tapped Horn Project