We have collected the most relevant information on Diyaudio Step Up Transformer. Open the URLs, which are collected below, and you will find all the info you are interested in.
Step-up transformer design | diyAudio
https://www.diyaudio.com/community/threads/step-up-transformer-design.161485/
Is there anybody out there that have tested these transformers? You can alter the step up between 1:9 and 1:129, from 150Hz. Hammond Mfg. - Universal Tube Output - Push-Pull Transformers - (125 Series) And buy them here: Das Musikding - Hammond 125E output transformer hamm125e •••
Step-up transformer comparison | diyAudio
https://www.diyaudio.com/community/threads/step-up-transformer-comparison.363266/
1. AudioStatic 2x1:75=1:150 step-up 2. DIY #1: 1:120 step-up 3. DIY #2: 1:90 step-up Transformer #2 end #3 were made by two different local hifi-enthousiasts. In the attachements you will find: * a saturation comparison. I put a 2 ohms resistor in series with the transformer and measured voltage across the resistor in order to calculate current.
MC Step-up transformers | diyAudio
https://www.diyaudio.com/community/threads/mc-step-up-transformers.84523/
Haufe transformers turn up fairly regularly. T42 has a step-up ratio of 1:20, T41 1:10. My guess is that they come from old Klangfilm gear. They were used as input/balancing transformers. All tend to bring around $100/pair. More if they are boxed or mounted. I believe Shindo and Auditorium 23 source their transformers from Haufe.
esl transformer. | diyAudio
https://www.diyaudio.com/community/threads/esl-transformer.55950/
Our Model 2.1 and 3.1 ESL have a usable frequency response of 175 Hz to 20 kHz with the M299B step-up transformer and crossover. Both models could be used down to 50hz with a higher turns step-up transformer say about 200:1 ratio but this step-up transformer would then only be able to produce up to 6khz in frequency response.
DIY MC Step-up Transformer - DIY Audio Projects Photo Gallery
https://diyaudioprojects.com/Gallery/displayimage.php?album=6&pid=736
DIY MC Step-up Transformer I the everlasting quest to better audio, I entered the realm of the moving coil phono cartridge with a Denon DL-103. To rise the output voltage of the Denon DL-103, I've build this Step-up transformer with two mic transformer from Edcor , I've use cast iron pipe bend with end plugs to make an electromagnetic shield.
Budgie Cinemag MC Step Up Transformer (SUT)
http://www.diyaudioblog.com/2014/02/budgie-cinemag-mc-step-up-transformer.html
A step-up transformer, or SUT for short, is needed to bring the low output level of moving coil cartridges up to the level of moving magnet cartridges, so one can use a traditional phono pre-amp for pre-amplification purposes. The SUT is plugged in right between the turntable and the phono preamp.
Now you know Diyaudio Step Up Transformer
Now that you know Diyaudio Step Up Transformer, we suggest that you familiarize yourself with information on similar questions.
