We have collected the most relevant information on Doc Hoyer Audio Transformers. Open the URLs, which are collected below, and you will find all the info you are interested in.


Audio Transformers - Roger Russell

    http://www.roger-russell.com/autran.htm
    ELECTROSTATIC SPEAKER TRANSFORMERS. WE DESIGN AND BUILD TRANSFORMERSFOR THE FOLLOWING TUBES: 813~845~211~300B~2A3~6C33C-B~KT-88/99. Contact Dennis "Doc"Hoyer at: PHONE. 414-774-6625. FAX. 414-774-4425. EMAIL.

dennis hoyer - Owner - Audio Transformers | LinkedIn

    https://www.linkedin.com/in/dennis-hoyer-51757742
    View dennis hoyer’s profile on LinkedIn, the world’s largest professional community. dennis has 1 job listed on their profile. See the complete profile on LinkedIn and discover dennis ...

Audio Classics 9B Tube Power Amp -- A Modern Day …

    https://forums.stevehoffman.tv/threads/audio-classics-9b-tube-power-amp-a-modern-day-marantz-9.515768/
    Yeah, Doc Hoyer has been the authority on output transformer rewind for as long as I can remember. Now, even if he is able to rewind a Marantz transformer successfully, then comes the daunting task of adjusting the feedback network to the transformer, as no two transformers were alike in this regard.

The Quest for the Ultimate

    https://worldradiohistory.com/hd2/IDX-Audio/Vacuum-Tube-Valley-IDX/IDX/Vacuum-Tube-Valley-03-OCR-Page-0018.pdf
    Eventually, I contacted 'Doc' Hoyer; sole proprietor of Audio Transformers, near Milwaukee, Wisconsin. The Doc is prob-ably the only man who can do the MI-200 transformer rewind. 'That will cost you a grand', he said. I packed the bad transformer up and shipped it to Wisconsin. Revival of the Fittest With the larger problems of getting

MC275 Transformers | diyAudio

    https://www.diyaudio.com/community/threads/mc275-transformers.184646/
    Hi Everyone, I'm looking to build an McIntosh MC275 and I know its quite a project, but I'm up to the challenge. I'm looking for the transformers. I talked to Doc Hoyer who can build them for me, but for $2000 which is a bit out of my range. Does anyone know where I can find some or if there...

Audio Asylum Thread Printer

    https://audioasylum.com/cgi/t.mpl?f=tubediy&m=238162
    Doc Hoyer is probably one of the biggest authoritarians on transformer technology in the country.I don't think McIntosh would have him winding their project transformers along with the Mi350 and 3500 transformers if he was a schmuck.I'm going to give the .32hy a try and execute it the way he told me just to see the measured results.

Cloning transformers | diyAudio

    https://www.diyaudio.com/community/threads/cloning-transformers.124076/
    Electra-Print, Magnequest, Doc Hoyer, Sowter, Heyboer, Bud Purvine, etc. As far as I know, the only times people have made clones for personal use (who haven't done it themselves for experiment) it has been at great expense through these …

Citation Series Resources (Under Construction)

    http://www.mcshanedesign.net/specs.htm
    The author of that quote is Doc Hoyer, the owner/operator of my recommended rewinder, Audio Transformers. No, it isn't inexpensive, but if you have a Citation that needs an output transformer, you have had little or no hope until now. The typical fee for a rewind is $450.00 (as of 12/00) plus shipping, but it's worth every penny in my opinion.

Audiogon Discussion Forum

    https://forum.audiogon.com/discussions/options-info-for-bad-scott-lk-150-power-transform
    I did contact Doc Hoyer who was recommended for a rewind of the existing transformer. He had not wound one of these units in the past. He would have to do a little reverse engineering along with the winding so his estimate was on the expensive side.

Suppliers for Vintage Electronics, Radio Parts, Tubes, etc.

    https://www.radiomuseum.org/forum/north_american_suppliers_for_vintage_electronics_28_nov_11.html
    The list below shows suppliers in North America for parts and restoration supplies for antique radios, electronic phonographs, tape decks, and TVs. This list is intended for suppliers that serve unique needs in the vintage electronics community, so the big modern electronics supply houses like Mouser, Newark, and Digi-Key are not included.

Now you know Doc Hoyer Audio Transformers

Now that you know Doc Hoyer Audio Transformers, we suggest that you familiarize yourself with information on similar questions.