Hairball Audio 1176 Schematic

Walkthrough of building a Hairball Audio 1176 - Bad Racket

https://badracket.com/building-an-hairball-audio-1176-peak-limite/

Hairball Audio 1176 One piece of gear I’ve always loved the sound of is the famed Urei 1176.You can get a wide variety of types of compression, from fast, clean, and smooth to slammed, pumpy, and dirty tones, as well as anywhere in between.

Hairball Audio: 1176 Blue Stripe clone | Tape Op …

https://tapeop.com/reviews/gear/84/1176-blue-stripe-clone/

Hairball Audio

https://www.hairballaudio.com/

You're finally at the end of your FET Compressor build and it's not working right. That sucks. Have no fear; we'll help you get it fixed. Read More. Learn how to use and connect your Hairball Audio microphone preamplifier to your interface. Read More. Learn how to route and add parallel compression to your mixes. Read More.

FET/RACK (NEW)Step 1: Building the Power ... - Hairball Audio

https://www.hairballaudio.com/blog/resources/build-guides/fetrack-v2-build-and-calibration-guide

Revision D Searchable PDF BOM, Schematic, Board Layout Revision F Interactive Build Map (PCB V1.15 and Earlier) Revision F Interactive Build Map (PCB V2.0 and Later) Revision F Searchable PDF BOM, Schematic, Board Layout. All Revisions: PCBs V2.0 and higher have R-OPT on the mainboard by the input t-pad. It is NOT supplied with the kit.

Hairball 1176 - Gearspace.com

https://gearspace.com/board/so-much-gear-so-little-time/946723-hairball-1176-a.html

the DON classics

https://www.thedonclassics.com/u76a-diy.html

• & an order from Hairball Audio (basket pre-prepared)> ... Schematics are available, or you can reference the original 1176 schematic. More questions have been answered in the Frequently Asked Questions Any other questions, don't hesitate to email: [email protected]. 500 series DIY KITS. NV73. Class A mic pre DIY kit. With or without EQ ...

Building DIY 1176 Compressor

https://www.masonaudio.org/diy/comp1176

FET/RACK A Limiter Main PCB Overlay ... - Hairball Audio

https://library.hairballaudio.com/docs/fet_rack_a_doc_v1.12.pdf

Main PCB Overlay, Schematic and Bill of Materials (T o C N 3) 2 1 N C 1 7 R C N 2 C N 4 C N 5 (T o V U) + + C B E C B E C B E C B E C E B E C B E C B D S G D S G B B C C E E Normal Operation-10V +30V Null Adj Q Bias T r a c k i n g A d j SIGNAL PREAMP SIGNAL LINE AMP GR CONTROL AMP GR METER DRIVER AMP S D G G D R23 R 5 6 + + K + + RCA1 ...

DIY Resource Center - Build Guides - Hairball Audio

https://www.hairballaudio.com/blog/resources/category/build-guides

The skills and knowledge you attain along the way will help you better understand how your gear works and can help you gain troubleshooting skills should something you own fail in the middle of a session. Our build guides listed below will walk you through every step in the build process with detailed images and diagrams.

Tape Op | DIY LA2A and 1176 - Message Board

https://messageboard.tapeop.com/viewtopic.php?t=68520