We have collected the most relevant information on Hdmi_Force_Edid_Audio=1. Open the URLs, which are collected below, and you will find all the info you are interested in.
Audio Passthrough not working …
https://github.com/OpenELEC/OpenELEC.tv/issues/2966
My TV dont send correct edid signal. I have to use hdmi_force_edid_audio=1 in config.txt. With latest build for PI this is not working. The text was updated successfully, but these errors were encountered: We are unable to convert the …
audio - sound output stuck on HDMI (working) - Raspberry ...
https://raspberrypi.stackexchange.com/questions/113997/sound-output-stuck-on-hdmi-working
You should try to comment out hdmi_force_edid_audio=1 in config.txt, add/uncomment hdmi_ignore_edid_audio=1 option, then reboot and try amixer again. Also you can check option hdmi_drive: hdmi_drive=1 Normal DVI mode (No sound) hdmi_drive=2 Normal HDMI mode (Sound will be sent if supported and enabled) Share Improve this answer
RPiconfig - eLinux.org
https://elinux.org/RPiconfig
hdmi_ignore_edid=0xa5000080 hdmi_edid_file when set to 1, will read the edid data from the edid.dat file instead of from the monitor. hdmi_edid_file=1 hdmi_force_edid_audio Pretends all audio formats are supported by display, allowing passthrough of DTS/AC3 even when not reported as supported. hdmi_force_edid_audio=1
7inch HDMI Display (H) - LCD wiki
http://www.lcdwiki.com/7inch_HDMI_Display_(H)
hdmi_force_edid_audio=1 max_usb_current=1 hdmi_force_hotplug=1 config_hdmi_boost=7 hdmi_group=2 hdmi_mode=87 hdmi_drive=2 display_rotate=0 hdmi_cvt 1024 600 60 6 0 0 0 Step 4. Insert SD card After the above steps are completed, pop up the SD card on the computer and insert it into the SD card slot on the back of the raspberry pie. Step 5.
Now you know Hdmi_Force_Edid_Audio=1
Now that you know Hdmi_Force_Edid_Audio=1, we suggest that you familiarize yourself with information on similar questions.
