Jl Audio 300/4 Low Ohms Light

JL 300/4 Low Ohm Light? | DiyMobileAudio.com Car Stereo Forum

https://www.diymobileaudio.com/threads/jl-300-4-low-ohm-light.45087/

I believe they are rated from 1 to 4 ohms of resistance. ! If you connect a load higher than 4Ω nominal per channel in stereo mode (or 8Ω in bridged mode), power will drop by half with every doubling of impedance above 4Ω stereo / 8Ω mono. If you connect a load lower than 1.5Ω nominal per channel in stereo mode (or 3Ω in bridged mode, the ...

JL 300/4 with Low Ohms Light On - the12volt.com

https://www.the12volt.com/installbay/forum_posts.asp?tid=109564

JL 300/4 with Low Ohms Light On - Just wired everything up, all were wired correctly. Triple checked. Brand new rear speakers, brand new RCA's, fairly new front speakers etc etc... The amp currently has no speaker wires hooked up, no RCA's hooked up. Only power, ground and remote. With the three wir

Low Ohm Light Issue and fix for $9!! JL Audio Slash v2 …

https://www.youtube.com/watch?v=JbR9bcK-VOw

JL Audio 300/4 Low impedance - Amplifiers - #1 Car Audio ...

https://www.stevemeadedesigns.com/board/topic/207306-jl-audio-3004-low-impedance/

I have a JL audio 300/4 I'm looking to install in my Cadillac with stock speakers for now. The front speakers seem to be as low as 1ohm. I know these amps can handle anything as low as 1.5 ohm's so does anyone if they're up for 1 ohm?

jl audio low ohm light Unsolved Problems (with Pictures ...

https://www.fixya.com/unsolved_problems/jl_audio_low_ohm_light

JL Audio Amp problem - the12volt.com

https://www.the12volt.com/installbay/forum_posts.asp?tid=32469

JL Audio Amp problem - I have a JL 300/4 amp i hooked it up and then the low ohm light lights up, and the sound comming out of the speakers is all choppy. does anyone know whats wrong with it? I hooked it up with out rcas and speakres hooked up and its the same. ...

Amplifier Status LED Colors & What ... - JL Audio Help Center

https://jlaudio.zendesk.com/hc/en-us/articles/225606727-Amplifier-Status-LED-Colors-What-they-Represent

All JL Audio amplifiers have built-in LED's that signify the operational status of that amplifier. It may show that the amplifier is working correctly, or identify a problem with the amplifier, installation or audio system itself. ... Low Impedance/Over Current: Incorrect speaker(s) used (measure voice coil impedance with digital volt meter)

JL Audio 500/1 Low Ohm Light | diyAudio

https://www.diyaudio.com/community/threads/jl-audio-500-1-low-ohm-light.371947/

Have a 500/1 here, came in shorted outputs. PS fine, drive with outputs out seem ok. Install outputs and as soon as rail builds drive to outputs goes away and low ohm light comes on. Output inductor tested ok out of circuit. Ideas?

HD Amplifier Troubleshooting Guide – JL Audio Help Center ...

https://jlaudio.zendesk.com/hc/en-us/articles/204374290-HD-Amplifier-Troubleshooting-Guide

HD Amplifier Troubleshooting Guide. Check the fuse (s), not just visually, but with a continuity meter. It is possible for a fuse to have poor internal connections that cannot be found by visual inspection. It is best to take the fuse out of the holder for testing. If no problem is found with the fuse, inspect the fuse-holder.

JL 1000/1 Low ohm Light + humming sounds - General Audio ...

https://www.stevemeadedesigns.com/board/topic/87077-jl-10001-low-ohm-light-humming-sounds/

my JL 1000/1 amp was working fine until suddenly it stopped working and producing screeching-humming sounds through my subs. I took a look at the amp and i noticed that the Low Ohm light was on. I disconnected everything besides the power wires and the low ohm light is still on. Also the amp is p...