We have collected the most relevant information on Mythtv Dual Audio Output. Open the URLs, which are collected below, and you will find all the info you are interested in.
Multiple simultaneous sound output - MythTV Official ...
https://forum.mythtv.org/viewtopic.php?t=141
Multiple simultaneous sound output. Post by jflatt » Mon Apr 28, 2014 2:28 am I am using this asound.conf, where hw:0,0 is analog out from motherboard sound, and hw:1,7 is HDMI. I point MythMusic to the 'dupe' audio device. ... I have MythTV set up to play HDMI audio through my TV so I can use the TV's remote control.
Simultaneous Audio Output to Independent Devices - …
https://www.mythtv.org/wiki/Simultaneous_Audio_Output_to_Independent_Devices
MythTv Setup. In the MythTv menus go to MythTv Setup / General / Audio System . and set the "Audio output device" to ALSA:default or ALSA:hdmi_dvi_both. Depending on your TV and Amp you may also need to change the settings for 5.1 sound. Your devices may or may not support AC3 (nothing else selected) Dolby; DTS; In my case,
Configuring Digital Sound - MythTV Official Wiki
https://www.mythtv.org/wiki/Configuring_Digital_Sound
Digital sound is the preferred method to get audio from a MythTV installation for two reasons 1. We want to have the audio decoding done outside of the computer for greater sound quality. 2. We want to play DVD with full surround sound using DTS or Dolby Digital. You need to be aware that ALSA by default will upsample all of your audio to 48 kHz.
Sound Troubleshooting - MythTV Official Wiki
https://www.mythtv.org/wiki/Sound_Troubleshooting
The hardware produced sound, but it was of the 2-channel variety. Dolby Digital output was produced by mplayer, though. After upgrading to a 2.6.19.1 kernel, MythTV could produce 5.1-channel output from appropriate sources (DVDs or files ripped from them). Another possible cause of too-few sound channels is mixer settings.
Digital Audio Tutorial - MythTV Official Wiki
https://www.mythtv.org/wiki/Digital_Audio_Tutorial
If you hear digital noise or what sounds like static from an old sci-fi movie, it is the digital spdif data stream being sent to the analog part of your sound card. Check your output aplay -l output again for the digital device. MythTV 0.23 …
Highly Technical Details - MythTV Official Wiki
https://www.mythtv.org/wiki/Highly_Technical_Details
VGA is the "normal" monitor cable everyone's used to seeing on computers and monitors. A great many of the LCD TVs currently being manufactured in the US are intended to be dual-purposed as computer monitors and will have a VGA input (and possibly DVI as well), and nearly all (some are coming DVI-only now) computer monitors being sold as computer monitors will accept VGA …
Digital audio out options for mythtv? - Linux/BSD
https://forums.whirlpool.net.au/archive/2789934
I use hdmi with myth 0.29. You will need to set it up yourself if you want to get the best out of it. The frontend will auto detect the audio hardware and you just have to choose the correct output in Setup->Audio. I tend to use direct hw output rather than alsa or pulse.
Category:HOWTO - MythTV Official Wiki
https://www.mythtv.org/wiki/Category:HOWTO
Category:HOWTO. Documents in this category are HOWTO documents explaining a specific scenario or task. You'll often find that they're more specific than you need, or that they pertain to a slightly different environment than you have, but you can often generalize about what they say to help you, anyway.
#13446 (Android Digital Audio) – MythTV
https://code.mythtv.org/trac/ticket/13446
" Audio playback capability for Android. Add a new audio output module for android devices. This supports digital passthrough as well as multi-channel LPCM. It also supports hardware accelerated decoding of media streams if your sound system does not support them. At this time there is a restriction that time stretch will use stereo or multi ...
Hauppauge HD-PVR - MythTV Official Wiki
https://www.mythtv.org/wiki/Hauppauge_HD-PVR
The Hauppauge HD-PVR is the first consumer-level analog HD capture device available. The HD-PVR is a USB device that captures the component video outputs and analog/optical audio outputs of any consumer device (including cable/satellite set-top-boxes, HD disk players, video game consoles, and various other home media devices). The HD-PVR is a …
Now you know Mythtv Dual Audio Output
Now that you know Mythtv Dual Audio Output, we suggest that you familiarize yourself with information on similar questions.
