We have collected the most relevant information on P3a Amplifier Diy Audio. Open the URLs, which are collected below, and you will find all the info you are interested in.
TGM8 - an amplifier based on Rod Elliot P3a | diyAudio
https://www.diyaudio.com/community/threads/tgm8-an-amplifier-based-on-rod-elliot-p3a.245619/
(edit) Note - what started out as an attempt to evolve the p3a has ended up as a complete redesign of every stage. The result exceeded all my expectations. This amplifier is my best. Anybody wanting to build this amp for DIY purposes (only) should find all they need in this thread. Some useful...
TGM8 - an amplifier based on Rod Elliot P3a | Page 34 ...
https://www.diyaudio.com/community/threads/tgm8-an-amplifier-based-on-rod-elliot-p3a.245619/page-34
Check also the collector load for the bootstrap transistor (R7 I think).
TGM8 - an amplifier based on Rod Elliot P3a | Page 57 ...
https://www.diyaudio.com/community/threads/tgm8-an-amplifier-based-on-rod-elliot-p3a.245619/page-57
Note - what started out as an attempt to evolve the p3a has ended up as a complete redesign of every stage. The result exceeded all my expectations. This amplifier is my best. Anybody wanting to build this amp for DIY purposes (only) should find all they need in this thread. Some useful posts: ...
DIY Audio Projects Forum • Elliot Sound Products - P3A ...
https://diyaudioprojects.com/Forum/viewtopic.php?p=19623
I am thinking of doing up my 2nd P3A board with Sanken transistors and a more robust power supply. _________________. Kind Regards, Dinesh. Some of my diy audio projects: Elliot Sound Products - P3A 100W Amplifier. TMM 2.5 Way Loudspeaker with Scanspeak 18W8546. 2-Way MTM Loudspeaker with Scanspeak 21W8554 and D2904-7100.
TGM8 - an amplifier based on Rod Elliot P3a | Page 32 ...
https://www.diyaudio.com/community/threads/tgm8-an-amplifier-based-on-rod-elliot-p3a.245619/page-32
Hi Guys, I finally got the boards populated. To my amazement, the first board fired up without issue. I was able to set the offset to zero and the bias control works properly. However, I haven't been able to find where it says what the bias …
DIY Audio Projects Forum • Elliot Sound Products - P3A ...
https://www.diyaudioprojects.com/Forum/viewtopic.php?t=2680
This Project 3A will deliver 100W into 4ohms, and 90W into 8 Ohms (35V and 42V PS respectively)! Distortion is a low 0.04% and is -1dB @ 10Hz. I decided on this amp because it is so simple, and am bored of that "Mosfet" sound !! This is a pure BJT power amp!
Now you know P3a Amplifier Diy Audio
Now that you know P3a Amplifier Diy Audio, we suggest that you familiarize yourself with information on similar questions.
