We have collected the most relevant information on Pulseaudio Auth-Anonymous. Open the URLs, which are collected below, and you will find all the info you are interested in.
PulseAudio/Examples - ArchWiki - Arch Linux
https://wiki.archlinux.org/title/PulseAudio/Examples
If it is undesirable to copy the cookie file from clients, anonymous clients can access the server by passing auth-anonymous to module-native-protocol-tcp on the server (again in /etc/pulse/default.pa): load-module module-native-protocol-tcp auth-anonymous=1 It is also possible to authenticate based on client IP address:
Modules – PulseAudio
https://www.freedesktop.org/wiki/Software/PulseAudio/Documentation/User/Modules/
auth-anonymous If set to true, no authentication is required to connect to the service auth-group (only for -unix) Members of the specified unix group may access the server without further authentication. If the daemon is running in system-wide mode (--system passed when starting up) defaults to pulse-access, otherwise is disabled.
PulseAudio - LinuxReviews
https://linuxreviews.org/PulseAudio
That parameter can be skipped, load-module module-native-protocol-tcp auth-anonymous=true would allow everyone access (note that everyone includes remote Internet users if the firewall permits it). The client(s) on the network would just need the following in /etc/pulse/default.pa to make a local pulseaudio use a remote pulseaudios outputs - if ...
[OpenWrt Wiki] PulseAudio
https://openwrt.org/docs/guide-user/hardware/audio/pulseaudio
# /etc/pulse/system.pa load-module module-esound-protocol-tcp auth-anonymous= 1. There is an issue with permissions in system mode with alsa. This is an workaround which does not support hotplug. In system mode pulseaudio runs under user pulse but it does not have the permissions to access alsa.
networking - How to set up PulseAudio remote properly …
https://unix.stackexchange.com/questions/470961/how-to-set-up-pulseaudio-remote-properly-and-securely
load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.0.0/24 auth-anonymous=1 load-module module-zeroconf-publish Run these commands: pulseaudio -k pulseaudio --start pacmd list-modules | grep native-protocol-tcp pacmd list-modules | grep zeroconf-publish The modules were correct. client steps
How to set up PulseAudio over Network · GitHub
https://gist.github.com/xarinatan/c415341ff34eab445cfb073988dcf6c1
At the end of the file, add load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.254.0/24 auth-anonymous=1 to activate networked audio from 192.168.254.0-255 without needing authentication. Kill pulseaudio, it should be auto-restarted, or restart your login session to activate the changes. You should now be able to set PULSE ...
PulseAudio with a VNC Terminal Server – Website of Stuart ...
https://www.stuartgraves.info/2022/01/25/pulseaudio-vnc-terminal-server/
Install Pulseaudio on the Pi (unless it’s already on there) pacman -Sy pulseaudio. Edit the global configuration file at /etc/pulse/default.pa, adding or uncommenting the following, to enable network support in PulseAudio. load-module module-native-protocol-tcp auth-anonymous=1. Optionally, for a little extra security ...
Now you know Pulseaudio Auth-Anonymous
Now that you know Pulseaudio Auth-Anonymous, we suggest that you familiarize yourself with information on similar questions.
