Pulseaudio Auth Anonymous | Audio-Digital.net

We have collected the most relevant information on Pulseaudio Auth Anonymous. Open the URLs, which are collected below, and you will find all the info you are interested in.

PulseAudio/Examples - ArchWiki - Arch Linux

https://wiki.archlinux.org/title/PulseAudio/Examples

If it is undesirable to copy the cookie file from clients, anonymous clients can access the server by passing auth-anonymous to module-native-protocol-tcp on the server (again in /etc/pulse/default.pa): load-module module-native-protocol-tcp auth-anonymous=1 It is also possible to authenticate based on client IP address:

Modules – PulseAudio

https://www.freedesktop.org/wiki/Software/PulseAudio/Documentation/User/Modules/

auth-anonymous If set to true, no authentication is required to connect to the service auth-group (only for -unix) Members of the specified unix group may access the server without further authentication. If the daemon is running in system-wide mode (--system passed when starting up) defaults to pulse-access, otherwise is disabled.

[OpenWrt Wiki] PulseAudio

https://openwrt.org/docs/guide-user/hardware/audio/pulseaudio

# /etc/pulse/system.pa load-module module-esound-protocol-tcp auth-anonymous= 1. There is an issue with permissions in system mode with alsa. This is an workaround which does not support hotplug. In system mode pulseaudio runs under user pulse but it does not have the permissions to access alsa.

PulseAudio - LinuxReviews

https://linuxreviews.org/PulseAudio

That parameter can be skipped, load-module module-native-protocol-tcp auth-anonymous=true would allow everyone access (note that everyone includes remote Internet users if the firewall permits it). The client(s) on the network would just need the following in /etc/pulse/default.pa to make a local pulseaudio use a remote pulseaudios outputs - if ...

networking - How to set up PulseAudio remote properly …

https://unix.stackexchange.com/questions/470961/how-to-set-up-pulseaudio-remote-properly-and-securely

load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.0.0/24 auth-anonymous=1 load-module module-zeroconf-publish Run these commands: pulseaudio -k pulseaudio --start pacmd list-modules | grep native-protocol-tcp pacmd list-modules | grep zeroconf-publish The modules were correct. client steps

Now you know Pulseaudio Auth Anonymous