Pulseaudio Default

PulseAudio - ArchWiki - Arch Linux

https://wiki.archlinux.org/title/PulseAudio#:~:text=daemon.conf%20%20%20%20Option%20%20%20,movies%20%20...%20%2012%20more%20rows%20

none

Set default profile for PulseAudio - Unix & Linux Stack ...

https://unix.stackexchange.com/questions/462670/set-default-profile-for-pulseaudio

1 Answer Active Oldest Score 44 Add the following to /etc/pulse/default.pa: set-card-profile <cardindex> <profilename> How do we figure out what to use as cardindex and as profilename? Here's one way. Configure the card so everything is working.

pulseaudio - Set default sound device output - Ask Ubuntu

https://askubuntu.com/questions/145135/set-default-sound-device-output

How to set Pulseaudio default - antiX-forum

https://www.antixforum.com/forums/topic/how-to-set-pulseaudio-default/

Up 1 For doing so, you can go to control-centre > session > configuration of the user It will open geany with the startup file, where you can add the line pulseaudio -D & After that, if you have also pavucontrol installed , which is recommended for pulseaudio,you can also right-click on the volume-icon in the tray, go to preferences,

Down the drain: The elusive ‘default’ PulseAudio sink ...

https://brokkr.net/2018/05/24/down-the-drain-the-elusive-default-pulseaudio-sink/

There is no such thing as a default output device (or sink) in PulseAudio. It say so right there in the official documentation. There is something referred to as a fallback device which is used “if the stream has not been seen before”. Yet there is …

linux - Set default sound card in Pulse Audio - Unix ...

https://unix.stackexchange.com/questions/53631/set-default-sound-card-in-pulse-audio

Changing default audio device in Pulseaudio. 13. Default sound volume for all ALSA devices. 0. set default audio input device as audio output. 1. Pulse audio doesn't load at startup. 1. Pulse Audio microphone from my laptop gives of a sound even when silent. Hot Network Questions

PulseAudio/Examples - ArchWiki - Arch Linux

https://wiki.archlinux.org/title/PulseAudio/Examples

Configuring Pulse-audio to use a remote server – Rotelok ...

https://rotelok.com/configuring-pulse-audio-to-use-a-remote-server/

On the server side you’ll need to enable the ‘module-native-protocol-tcp’ pulse-audio module, this module usually is already installed by but for security reasons it comes as disabled by default. You’ll also need to open port tcp/4713 on your firewall. After that you need to copy the file ‘~/.pulse-cookie’ from the server to every client.

linux - Pulseaudio set/check default source - Stack Overflow

https://stackoverflow.com/questions/59150186/pulseaudio-set-check-default-source

PulseAudio - LinuxReviews

https://linuxreviews.org/PulseAudio

Both default to no HOWTO choose default-sample-rate The short answer: 48000 Hz is likely the best option on most modern hardware. PulseAudio can operate using two different sample-rates by configuring default-sample-rate = 44100 alternate-sample-rate = 48000