We have collected the most relevant information on Pulseaudio Line In Monitor. Open the URLs, which are collected below, and you will find all the info you are interested in.
Setting the default pulseaudio capture source to "monitor ...
https://unix.stackexchange.com/questions/596823/setting-the-default-pulseaudio-capture-source-to-monitor-via-command-line
analog-stereo.monitor is a Pulseaudio source for audio recording. It would not be recognised by ALSA when used in file ~/.asoundrc. to see information about Pulseaudio sinks and sources, including defaults: pacmd dump default-source for recording can be set with: pacmd set-default-source alsa_output.pci-0000_00_1b.0.analog-stereo.monitor
linux - Pipe/Mix Line In to Output in PulseAudio - Unix ...
https://unix.stackexchange.com/questions/263274/pipe-mix-line-in-to-output-in-pulseaudio
I want to listen to both by piping the non-Linux computers' output into the Linux computer's line in (blue audio jack) and mixing the signal into the Linux computer's headset output using PulseAudio. pavucontrol shows a "Built-in Audio Analog Stereo" Input Device which allows me to pick ports like "Line In" (selected), "Front Microphone", "Rear ...
Monitoring Audio Levels with PulseAudio · menno.io
https://menno.io/posts/pulseaudio_monitoring/
Monitoring Audio Levels with PulseAudio. Posted on May 08, 2013. I'm working on driving an analog VU meter from my Raspberry Pi using whatever audio is going out the Pi's sound outputs. The de facto Linux sound system, PulseAudio, allows any sound output (or "sink" in PulseAudio's nonclementure) to be monitored.In PulseAudio land, each sink has a …
Pulseaudio: Listen to line in through speakers and use ...
https://archived.forum.manjaro.org/t/pulseaudio-listen-to-line-in-through-speakers-and-use-microphone-for-communication/105824
Headphones mix = Line-In + Discord - Mic. Discord mix = Mic + Line-In - Discord audio. hardware must have 2 audio capture device/sub-devices listed in arecord -l to support simultaneous use of both Line-in and Microphone your hardware probably does if it works in another OS. but only one sub-device may be available at any time in default Pulseaudio
PulseAudio from the Command Line - Shallow Sky
https://shallowsky.com/linux/pulseaudio-command-line.html
Controlling PulseAudio from the Command Line. Controlling PulseAudio via pavucontrol is all very nice, but it's time consuming and fiddly: you have to do a lot of clicking in a lot of tabs any time you want to change anything.. I wanted quick ways to do a few things I do a lot: turn all microphones off (this is a big one!); switch to the external speakers so I can listen to music; …
Now you know Pulseaudio Line In Monitor
Now that you know Pulseaudio Line In Monitor, we suggest that you familiarize yourself with information on similar questions.
