Pulseaudio Network Configuration

We have collected the most relevant information on Pulseaudio Network Configuration. Open the URLs, which are collected below, and you will find all the info you are interested in.

Network Setup – PulseAudio

https://www.freedesktop.org/wiki/Software/PulseAudio/Documentation/User/Network/#:~:text=Network%20Setup%201%20Direct%20connection.%20Just%20set%20the,4%20%21AirPort%20RAOP%20streaming.%20With%20module-raop-sink.%205%20Rygel

none

PulseAudio Network Configuration, Raspberry Pi Server ...

https://andre.blaatschaap.be/2020/06/pulseaudio-network-configuration-raspberry-pi-server/

Publishing in the network is done with the module-zeroconf-publish module. # Adding listen=0.0.0.0 to force it IPv4 only, otherwise it will use both IPv4 and IPv6 and it appears twice load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.1.0/24 auth-anonymous=1 listen=0.0.0.0 load-module module-zeroconf-publish

PulseAudio Configuration | Linux Sound

https://linuxsound.wordpress.com/2011/03/29/pulseaudio-configuration/

There are 3 places to change the configuration parameters and behavior of PulseAudio. system.pa/default.pa – startup script to specify module loading, etc, module parameters are passed here, more on that later. client.conf – does just what is says, config file for clients. daemon.conf – configuration specific to the sound server daemon.

networking - How to set up PulseAudio remote properly …

https://unix.stackexchange.com/questions/470961/how-to-set-up-pulseaudio-remote-properly-and-securely

Edit /etc/pulse/default.pa and add these lines: load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.0.0/24 auth-anonymous=1 load-module module-zeroconf-publish. Run these commands: pulseaudio -k pulseaudio --start pacmd list-modules | grep native-protocol-tcp pacmd list-modules | grep zeroconf-publish.

PulseAudio - OpenWrt Wiki

https://openwrt.org/docs/guide-user/hardware/audio/pulseaudio

pulseaudio Configuration With PulseAudio it's possible to send audio over the network. There are several ways to achieve that, here's the “tunnel”-approach described. For other solutions see the PulseAudio wiki . Server configuration For sound from the network, something like this is needed:

Now you know Pulseaudio Network Configuration