We have collected the most relevant information on Pulseaudio Perfect Setup Guide. Open the URLs, which are collected below, and you will find all the info you are interested in.
The Perfect Setup - freedesktop.org
https://www.freedesktop.org/wiki/Software/PulseAudio/Documentation/User/PerfectSetup/
After you've compiled Myth with this patch, configure alsa as described above. Then from mythfrontend, go to Utilities/Setup->Setup->General->Next->Next, and set Audio output device to 'ALSA:default' if you configured pulse to be the default output device, or 'ALSA:pulse', it pulse hasn't been configured to be the default.
networking - How to set up PulseAudio remote properly …
https://unix.stackexchange.com/questions/470961/how-to-set-up-pulseaudio-remote-properly-and-securely
pacman -S pulseaudio-zeroconf systemctl enable avahi-daemon.service systemctl start avahi-daemon.service server steps. Edit /etc/pulse/default.pa and add these lines: load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1;192.168.0.0/24 auth-anonymous=1 load-module module-zeroconf-publish Run these commands: pulseaudio -k pulseaudio --start …
Pi Guide - How to Setup PulseAudio as A System Wide ...
https://www.youtube.com/watch?v=xQ1-FLRTcoM
This is a tutorial on how to setup PulseAudio as a system wide service on Raspberry Pi. How to setup PulseAudio as a system wide service. Setup PulseAudio as...
PulseAudio - Official Kodi Wiki
https://kodi.wiki/view/PulseAudio
PulseAudio can be run in one of two modes these are: Passthrough Mode Used if you want to passthrough (bitstream) AC3, DTS, and EAC3 to an AVR or other device. In order to allow passthrough to work with PulseAudio then it MUST be set to use a 2.0 channel configuration, despite the 2.0 setting this will still allow 5.1 audio from AC3, DTS, and EAC3.
PulseAudio - Community Help Wiki
https://help.ubuntu.com/community/PulseAudio
In 11.04 the default setup does not allow sound to play when switching out of the xorg GUI, or when logging out of the GUI or stopping the GUI completely. The solution to allow sound to play outside of the GUI (for use with MPD for example) is to make sure the user is added to the audio, pulseaudio and pulse-control groups ...
How-To: Pulseaudio - Page 1 - Debian User Forums
https://forums.debian.net/viewtopic.php?t=12497&start=15
You should use pulseaudio -D as user, not as root (systemwide) and then you don't need to change the group-file (on Lenny the pulse user added itself to the audio group). Also you need to add yourself to the pulse-rt group only if you want to use the realtime functions, which pose a security risk. Top. DrumScum.
Now you know Pulseaudio Perfect Setup Guide
Now that you know Pulseaudio Perfect Setup Guide, we suggest that you familiarize yourself with information on similar questions.
