We have collected the most relevant information on Pulseaudio Rtp Howto. Open the URLs, which are collected below, and you will find all the info you are interested in.
How to listen to the pulseaudio RTP Stream - freedesktop.org
https://freedesktop.org/wiki/Software/PulseAudio/Documentation/User/Network/RTP/
How to listen to the pulseaudio RTP Stream. How to get the multicast address and port - the quick and dirty way - with tcpdump; Play it using mplayer; Play it using rtpdump and sox (invoked as "play") Play it using rtpdump and aplay; Play it using vlc; Stream it …
audio - PulseAudio RTP - how to play sound on sender …
https://unix.stackexchange.com/questions/471222/pulseaudio-rtp-how-to-play-sound-on-sender-too
Use module-combine-sink. On the sender: pacmd list-sinks. Use the values of the of each sink to be combined in slaves list below: pactl load-module module-combine-sink sink_name=rtp1combined slaves=abcd,wxyz. where abcd and wxyz would be the names of the two sinks to combine. In my case, that would be slaves=rtpsink1,alsa_output.pci …
Use PulseAudio and RTP to stream audio within your local ...
http://www.kikeriki.at/pulseaudio-rtp.html
To better understand what is going on we will also use pulsemixer. Install both using. # pacman -S pulseaudio-rtp pulsemixer. Find out the IP address of the device you want to send audio to and load the rpt-send module using. $ pactl load-module module-rtp-send port=4444 destination_ip=192.168.1.3.
PulseAudio RTP – how to play sound on sender too – iTecTec
https://itectec.com/unixlinux/pulseaudio-rtp-how-to-play-sound-on-sender-too/
pactl load-module module-rtp-recv sap_address=192.168.0.X Use the receiver's actual IP address, e.g., 192.168.0.2. Finally, on the sender, make it a receiver too: pactl load-module module-rtp-recv sap_address=192.168.0.1 You can make the configuration on the receivers permanent by editing /etc/pulse/default.pa
How to Stream Audio to Raspberry Pi via PulseAudio RTP ...
https://stackoverflow.com/questions/57451900/how-to-stream-audio-to-raspberry-pi-via-pulseaudio-rtp-unicast
I am trying to stream audio from a Linux Mint Desktop to a RaspberryPi 3B running LibreELEC (Kodi) using PulseAudio RTP. I can successfully stream the audio with RTP multicast: Desktop: pactl load-module module-null-sink sink_name=rtp pactl load-module module-rtp-send source=rtp.monitor Pi: pactl load-module module-rtp-recv latency_msec=50
Now you know Pulseaudio Rtp Howto
Now that you know Pulseaudio Rtp Howto, we suggest that you familiarize yourself with information on similar questions.
