We have collected the most relevant information on Pulseaudio Spdif Ac3. Open the URLs, which are collected below, and you will find all the info you are interested in.


Problem with 5.1 AC-3 through Alsa, Pulseaudio on SPDIF ...

    https://askubuntu.com/questions/483555/problem-with-5-1-ac-3-through-alsa-pulseaudio-on-spdif-ubuntu-14-04
    14.04 pulseaudio alsa spdif ac3. Share. Improve this question. Follow edited Jun 17 '14 at 9:19. John N. asked Jun 15 '14 at 9:44. John N John N. 41 1 1 gold badge 1 1 silver badge 5 5 bronze badges. 1. I have the same problem, if you use VLC to play, all you have to do is changing the audio output module from default to Pulseaudio.

Getting DTS 5.1+ sound via S/PDIF or HDMI using PulseAudio ...

    https://blogs.gentoo.org/mgorny/2021/07/25/getting-dts-5-1-sound-via-s-pdif-or-hdmi-using-pulseaudio/
    Finally, you have to enable S/PDIF passthrough (the same option is used for HDMI) in mpv, via ~/.config/mpv/mpv.conf: audio-spdif=ac3,dts,eac3 audio-channels=5.1 The full list of formats can be found in mpv(1) manpage. If everything works fine, you’re going to see something like the following in mpv output: AO: [alsa] 48000Hz stereo 2ch spdif-ac3

[SOLVED] AC3 - SPDIF Passthrough - Pulseaudio - Karmic …

    https://ubuntuforums.org/showthread.php?t=1304614
    Hello, This isn't a request for assistance, just a tip as I didn't see much else for SPDIF passthrough and Karmic. When I upgraded to 9.10 from 9.04 my SPDIF passthrough was no longer working. In 9.04 I would use Pulseaudio for everything but DD or DTS audio. All sound would still go over SPDIF. I had SMPlayer set up to directly access the SPDIF hardware device …

Jaunty = pulseaudio = no AC3 DTS passthrough from spdif

    https://ubuntuforums.org/showthread.php?t=1151680
    AC3 (Dolby Digital) is signed 16-bit little-endian 2-channel 48kHz PCM data (as far as we want pulseaudio and ALSA to be concerned), but the default pulseaudio sample-rate is 44.1kHz, so when an application attempts to connect to pulseaudio for passthrough pulse rejects the connection because of the sample-rate.

PulseAudio for analog/spdif hell – so simple, yet you have ...

    https://blog.kanojo.de/2011/09/18/pulseaudio-for-analogspdif-hell-simple-yet-you-gotta-find-it/
    PulseAudio for analog/spdif hell – so simple, yet you have to know…. 18.09.2011 by Nebukadneza. When it comes to a flexible audio setup Alsa starts to suck … hard. If you want output mainly on S/PDIF (be it optical or coax), automatically upmixed to 5.1, then encoded to A52 so your receiver will eat it, but sometimes your general AC3-passthrough 5.1 movie, …

Now you know Pulseaudio Spdif Ac3

Now that you know Pulseaudio Spdif Ac3, we suggest that you familiarize yourself with information on similar questions.