We have collected the most relevant information on Ts 480 Audio Mods. Open the URLs, which are collected below, and you will find all the info you are interested in.
mods.dk - Articles for Kenwood 'TS-480'
https://www.mods.dk/index.php?ModelId=769
TS-480 PEP power level mod: 29 Jun 2006: TS-480 Replacing the standard MCF (monolithic crystal filter) 07 Jun 2006: Proper microphone wiring for TS-480SAT: 10 Apr 2005: Reversing Grounds Fixes RF in Non-Stock Mic Print this message: 01 Apr 2005: Kenwood Updates TS-480HX/SAT Firmware: 07 Jan 2004: TS-480SAT/HX beyond MARS mod
TS 480 HX PEP POWER LEVEL MOD - angelsnz.net
https://www.angelsnz.net/ZL3SV/misc/TS-480-PEP-Power-increase-mod.htm
The maximum I would go to is 200 watts PEP as the inter-mod becomes well out of the TS 480 HX spec. After this mod you will need to watch your levels and band width if you use the compressor above 60%. If you keep an eye on the ALC you should be fine. The two tone test now shows 70 watts RMS output on a Bird watt meter and that equals 200 watts PEP as a rough …
IU2MEH: Kenwood TS-480 SAT audio cable for digi modes
https://iu2meh.blogspot.com/2019/05/kenwood-ts-480-sat-audio-cable-for-digi.html
Kenwood TS-480 SAT audio cable for digi modes. I'm a happy owner of the rig Kenwood TS-480SAT, I will share how I made the audio cable to interface the rig to a computer to work with digital modes like FT-8. The minidin connector named DATA in the rig manual is basically the same as the old PS/2 cable for mouse or pc keyboard. You can take an ...
TS-480 to PC Audio for Digi Modes | QRZ Forums
https://forums.qrz.com/index.php?threads/ts-480-to-pc-audio-for-digi-modes.667879/
Looking for recommendations for interfacing TS-480 to my laptop for use with WSJT-X for FT-8 and other digital modes. I have the serial cable connection for rig control, just need to interface the audio to/from the radio to the PC's sound card mic and speaker jacks.
KENWOOD TS-480SAT/HX BEYOND MARS MOD
https://www.qsl.net/sp9hzx/pdf/ts-480_mars-cap_mod.pdf
KENWOOD TS-480SAT/HX BEYOND MARS MOD de K0ZL es DJ6TJ: rev 1 February 2005 1. Turn off the transceiver and disconnect the antenna and DC supply. 2. Remove the top panel (8 screws). 3. Remove 4 screws from the shield plate and then remove the plate to access the TX-RX (A/2) board (this shield plate is toward the front of the radio and only has 4 screws).
Now you know Ts 480 Audio Mods
Now that you know Ts 480 Audio Mods, we suggest that you familiarize yourself with information on similar questions.
